Separate names with a comma.
Some features disabled for guests. Register Today.
This little compressor doesn’t use too many amps but I’m on a 20A
I didn’t use a ton of oil just started with a small squirt and another about half way through. The air blasting blowing most of it away anyway....
Yes, could rough it out with tablesaw and cnc to spec?
Could just use a router or router table, cut manually Gary
Totally agree, I just ordered the ubiquitous mist/air setup on amazon, hoping to incorporate it into my dust shoe, my vac isn't strong enough to...
A "bit" embarrassing (after the post above) but also a milestone for me, I was able to slot cut yesterday! Using a 3mm O-flute, 500mm/min, 0.5mm...
Best makita collet first 1/8 and any other size is probably elairecorp.com/site/makitaroutercollets.html?imz_st not cheap and shipping hurts too...
Install the drivers ? <link to the drivers Cheers Gary
I've never gotten shallow slots to work without welding aluminum to the bit, my machine isn't stiff enough to push through at low RPM. With...
Hi Rob, post your GRBL settings so we can see whats up. If cutting aluminum make sure no chips are getting on the board, and clean it with...
Hi Travis, looks like your router power cable is in the cable chains? Might be the cause. Either string it outside and up out of the chains or if...
To cut wood with a laser you really need an "air blast" to clear the smoke, and more than 1 pass ends up with nasty char on the edges.. my...
Gaming type desktop or laptop? did you check USB suspend setting? Could it be thermals? what motors are you driving and how high do you have the...
Hi Oliver, best place to ask questions is on the BlackBox forum page, BB is pre-loaded, did you install the drivers on your PC? follow the...
Hi Ricky, welcome to the forum! you will get faster help with a question if you post the question in the section of the forum devoted to the...
Hi Richmond, halfway down this page you will see instructions on setting motor current. For sure get a cooling fan blowing on it, and check those...
Hi Peter, Looks like a loose setscrew on the pulleys Cheers Gary
It might be the aluminum is not an easy to machine alloy? 6061 is common for its easy (easier than others) machining properties. Also that looks...
Hi Mateusz, For safety you should get a three wire cable/plug (hot-neutral-earth) for that PSU. Then the chassis of the PSU will be protected and...
Ok, well they usually are on the bottom, and should be adjusted till it tightens up the wheels, looks like they already adjusted maxed out? I can...
