Separate names with a comma.
Some features disabled for guests. Register Today.
Yes that's an easy fix, drawing the holding tabs. Cheers Gary
Oh Bats forgot to say.. regarding the A-B-C axis, Makes sense, I worked with commercial 6 DOF flight simulators and those would have been...
After re-watching Christian's videos, it looks like sometimes there is the lift after each 3D pass and sometimes there is not. Wonder if it comes...
yes, in the time it took you to write all that I could have fixed it for you.. maybe even twice ;) you are too much! lol
Good to hear you got it sorted, I think those will last a while like that, always good to have some spares just in case. Cheers Gary
Washer spacer in-between the bearings? if so make sure the bearings are fully seated, sometimes you need to press them firmly between two flat...
Tilt the gantry at the plates (if A-B is what i think it is), Or there should be enough play in the cast angles to move it where you need (using...
I'm sending the creator of Estlcam an email, hopefully he will help us. meanwhile it might be worth re-watching these two videos. [MEDIA] [MEDIA]
I don't think that will work, the Xpro is practically an arduino with GRBL pre-compiled on it. Use the arduino to drive some cheap steeper...
It uses a standard printer type usb cord, and usb 2.0 would be plenty. Cheers Gary
Normally Open is still NO, but when the arduino commands (NO to closed) it takes signal to ground (Like NPN transistor).. that's how all the...
I agree the MDF is not the best material in this use case, I think you guys are way over thinking it. Given that 4 open-wheels are all that...
LOL, yes I have seen the same thing when doing an STL file recently, also with V-carving of text. Unfortunately there are so many variables to...
Marc, Did you try swapping x and y (step and direction output) at the xpro? this would rule out the Y channel being bad. My guess would be you...
That’s the key that I think some miss.. Thanks Batcrave! Gary
If you are using Arduino already just get drivers. Did you already acquire the control program for Arduino and the joystick?
Isn't there a way to change the current setting with those sheilds? I looked at the stepper control page and there is no mention of changing amps...
Hi Bribeck, those little adafruit steppers are only 350mA motors, the Openbuild ones are 1800mA (they are bigger). You probably need to turn up...
The router is not resting on the lip at the end of the router, the clamping force is very secure. I put heat shrink around the hose clamps to...
Could do it like this, temporary mounts .. really didn't see any improvement with aluminum vs the hose clamp mounts.. the black parts are hdpe but...
