Separate names with a comma.
Some features disabled for guests. Register Today.
Hi Shane, Belt slip? they should never jump over a tooth, did you get the pulley and the belt from the same supplier? Did you loctite the pulley...
Without dual belts it's easy, just fish the belt through.. with dual belt, not so much :) Cheers Gary
Always start your system (first start) with nothing connected and get everything sorted and moving correctly before connecting the couplers to the...
Oh ok, thought you were using ATX which in that case the solder jumper sets it to use the ATX standby feature. You should not need the jumper at...
E-stop should not lock the motors, is it just NO instead of NC? can you run with the e-stop pressed? did you follow this? [ATTACH] Cheers Gary
Hi MHSB, don't worry about the version, it's not the issue. Have you loaded the xpro drivers on your pc? found here I think arduino driver works...
show us your interface settings, thanks Gary
openbuids controller? xpro maybe? Most likely a loose or broken wire connection to that motor. cheers
Are you sure they are both going the correct direction? disconnect the screws and make sure they are both going in the same direction first. Also...
too deep of a cut maybe.. need more info
Yes that is reversed good find. might not have been what let the magic smoke out, but doesn't help either. Yes those drives will fully power the...
Sounds like a good plan for next steps.. As for a driver replacement, there are many 542 type drives, the ones from Openbuilds are excellent and...
Hi Dale, You can slave many drivers to one axis by running the step and direction signals in parallel to the drives. Cheers Gary
David, He's using Estlcam which uses mm per rev... I agree about the speed Cheers
I do not know, I will find out when everybody else does :)
Hi Rob, Depends on if you plan on using bigger nema23 motors or not, the xPro can do 1.75A (2.5A peak) per channel where as the BB can do 3.25A...
I think this is it, or something just like it... [MEDIA]
More info would help, what you mean by "problems"? and what type of machine you have? Could be lots of things besides rollers and screws.. Maybe a...
Nothing wrong with using the earth grounds all together, as long as the outlet you are using is wired correctly! That can be checked easy enough...
Hi M&D, Any pictures? what type brand PSU? what type speed control, 0-100vdc spindle? Do the PSU's have selection switches to run on 120vac?...
