Separate names with a comma.
Some features disabled for guests. Register Today.
This is in German but the first thing i thought of. Good luck. Also the ball end is done with the last part of the tool specs on the right side of...
I used to make RC airplane kits, had an issue with one postal worker who thought it was Ok to fold the box in half so it fit in her van better......
You are fine, it just looked at 0.0375/0.005 = 7.5 You have it set correct. Cheers Gary
Isn't (or now wasn't) that motor shield one channel? you need three axis, there are many cheap options (which will take 24V) out there.. I'm not...
Giarc, He's using an Xpro, but I agree the #7 is probably a carry-over from the Uno D3 is the probe on Xpro [ATTACH]
I'm guessing that voltage regulator is not able to handle true 2.5A like it says. What is the goal of this project? Maybe we can help. Is this the...
I don’t know why you would use that type of PSU, all you need is a switching constant voltage PSU, if you can set the one you have to a fixed...
Hi, we need more details to help. Like what power supply model, what drivers are you using.. The power supply powers the drivers and the driver...
Ok so that's easy, you need to change input 7 to "probe", not 1. Cheers
Hi Defender, Do you have one wire going to your endmill and another to the plate? A picture might help us, also make sure the input is setup in...
Grimace, did you try adjusting the current pot? really sounds like too low current.
Yes and that gap seems to be 0.5mm which can be done with tape or I used 4x0.5mm carbon fiber strips, and CA glue which bonds to the...
Ah yes, there is that, good point. Cheers
Yes DXF drawing with draftsight is all you need. There used to be plugins for sketchup which made DXF files from any sketch but I gave up on...
Been using this one, 1" - 1/4" shank $12 on amazon
Hi Phillip, Check your sender settings. There is a truncate setting and a max command length setting. You can make the max character setting...
Short and slow drill pecks and you should be good. I was able to drill the holes for M4 threads and my linear rail bolts lined up nice, with an...
Did you follow my link to the super cheap short flute drills? These type are commonly used for drilling rivet holes in aluminum. They have a tip...
Flint, you think PC is expensive wait till you start looking at the fancy high tech engineering plastics, they are crazy. :eek: Cheers
Last time I used it I did a 1mm peck with 400mm/min z speed, had the makita set to about a 3.
