Separate names with a comma.
Some features disabled for guests. Register Today.
yeah i got a cheap 100 tooth 10inch one on ebay cuts great, but a fine tooth woodworking carbide blade works great as well. Just make sure to...
I've always considered a decent table saw to be a basic human necessity ;) (tell your wife that's from the World Health Organization) Dimensional...
many cad programs can open IGS files, and there are many IGS to DWG converters out there as well.
Sounds like you don’t have the coils matched up to the driver outputs.? The board is happy until it tries driving a motor.
Basically current is torque voltage is speed.
Hey off topic rants are what makes a thread interesting sometimes!
2.6 would be fine, at 3 they might run too hot. Hot is when you can not hold your hand on it for more than a few seconds. Warm is just fine.
Y Yes, I agree i'm a big fan of the arduino and discrete drivers, that's what I use.. but the original question was... "Can the X-Pro be used...
I thought the Xpro had solder tabs on the back for using discrete drives? maybe it's just the v3?
Ok, that must be it, didn’t realize it was customized, thanks Rick
Strange that this Control Software area doesn't seem to be linked to "new post"?
the Makita RT0701C many of people use is very quite in the 10000-16000RPM range. I feel that many people run unnecessarily high RPM. When I'm...
You are off to a good start the plates look great!
Savvas did a Acetel (Delrin) cnc machine very successfully, Corian is actually over 2x stiffer than acetel so this will work fine.. the only issue...
I've been using Estlcam now for a few months, really impressive CAM program, love it! BUT I've been hesitant to reflash the Arduino Uno with the...
I didn't think there were 5 wire steppers, the 5th connection is just ground?
many steps to do, there are a lot of instructions on the product page... [ATTACH]
Need more info, what have you tried? what is the issue exactly? and a pic of it setup.. also i think you want to disconnect the enables, just pull...
Yes, love it, you can use it free (until the timer gets long and you just pay) and just generate the g-code for grbl or whenever you use. I have...
You might be right, found an interesting chart on coatings.. Harvey Tool - Coating Chart for Ferrous and Non-Ferrous Materials
