Separate names with a comma.
Some features disabled for guests. Register Today.
Most people are using fast decay for the solder jumpers on the back of the board. If is was mine i would use a small jumper wire first on X or Y...
Ok, only thing that still looks strange is the $0 is 3 instead of 10 which is default I thought? Using an xPro V3 right? You did the fast decay...
what happens when you use the 500mm/min feed rate? sometimes slow feeds act weird with grbl. Jogging can do strange things as well.
yes, I run my ox at 700 for x and y and 600 for z, but i have bigger motors and dq542ma's so it will be different.
try turning your acceleration up, should be able to run around 500 to 600, you are accelerating and decelerating for each line segment, never...
You can replace the makita cable very easily take the top cover off and there are screw terminals, replace the cable with shielded 2 conductor of...
Hey Foggin, what's your microstep and decay set to? list your $$ settings for us. are your wheels super tight? might be too tight Cheers
yeah the 8mm side is a loose fit on the openbuild screw, I used a couple layers of aluminum foil duct tape to take up some of the gap. Clamp screw...
That kind of difference of calculated vs calibrated is typical and fine. I've been wanting to try the Estlcam sender myself because i want to try...
and the set screw... maybe they just sent the wrong one?
yes that's a big one for sure, it's very easy to replace your router cable with a shielded pair cable, run the drain to the star ground, for the...
whats the max character length set to in UGS? are the lines in your code reaching 50+ characters including spaces
Can you share a screenshot of the drawing? I think you might be right with 15's, i was looking at the v-slot the other day and realized that 9mm...
You would need to look at the driver(s) you have and RTFM ;)
Personally I would not risk a $120 board when a $16 arduino Uno can do this, save the xPro for another project.. it's perfect for lower power more...
I would think 9 would be size appropriate, the 15 and 25 would be so huge in comparison to the machine.. You can model the parts easy enough using...
I can not get slotting to work reliably with aluminum either. I have done 1/2" 6061 with trochoidal milling using Estlcam in 3 passes (1/8" bit),...
Having to disassemble and re-assemble many times due to forgotten T-nuts is an openbuilds right of passage! So you are doing it right ;)
XPro is stand alone (has built in drivers) does not have outputs for external drivers, all you need is a $16 Arduino Uno for that.
They have a good selection of these at http://www.omc-stepperonline.com/ I've been thinking one of these would make for a nice compact Z axis drive.
