Separate names with a comma.
Some features disabled for guests. Register Today.
Yes for sure, even worse is my 100 tooth 10" aluminum cutting table saw blade, makes these beautiful square foil chips that flutter through the...
4560mm/min? that's screaming fast, but my guess is your X motor pulley setscrew is not set tight on the flat of the stepper shaft. check the...
If you don't use glue or double sided tape why even dual belt? reminded me of the Flaming Lips "She Don't use Jelly" song!
I use a modified harbor freight 2HP DC (not known for the best dynamic pressure), made into a thien baffle type, and I choked my router...
What micro steps are you running? also post your GRBL $$ settings that is rough! You should probably start a new thread for yourself, or get this...
Is it for this, Link to the part...? a 15/32" drill will do it. they recommend a drill guide (access hole jig), i can't find one for the 20 series!
The motors being energized and locking into place..
yes, this is how most Y's are setup with two motors.
Edit; i re-read what you wrote and yes this is confusing !! weather it's A - B or B- A makes no difference, as long as A's are together in some...
David the Swarfer post on setting up uno
I don't know how true it is but most people will say the true Uno has better luck with data rates. You might have issues with the clone. The real...
The hardest part for me was finding free to cheap software that i was happy with and performed well, at first it was quite a struggle, now i'm in...
Thanks David, good to know the limit is 80, I did show the screenshot of the location above, for the latest ugs platform version. Works like a...
Ok Thanks, i counted and had 59 characters at one point.. use arduino uno, grbl 1.1 post setting on estlcam, my spindle is manual speed (makita...
Not doing the feed and speed every line, but when it does with the helical drill its too long (over 50 at least), and there are spaces.. just not...
Julius! thanks, I don't know why i didn't notice that, i'll see in Estlcam how i can stop that every line.. but for now i made the commandLength...
I'm using UGS platform (32), doesn't matter what version i tried a few of them including the latest nightly, and i keep getting this error (below)...
That pic i posted is from the spark website.
is there a picture of the correct graphic? is this one correct? [ATTACH]
Could that explain his motor heat issue too?
