Separate names with a comma.
Some features disabled for guests. Register Today.
Depends on the location and the plate thickness. In the areas where you're bolting through a plate into a T-nut that is in the channel in the...
Rather than replacing the steppers with 400 step steppers consider replacing the TR8*8 screws with T8*2 screws. This will improve resolution by a...
Don't toss the spindle just yet. Let's see if you can stabilize what you have first and then see if you can make it work. As for purchasing the...
Yup, as Kevon notes you broke just about every rule in the book here. You've got to be low and tight if you want decent results. Drop the powered...
No, the plate is running outside the C-beam. The belt is located inside the channel though.
With the right plates yes. One example would be the OpenBuilds Workbee 1510 (60" x 40")
If you seek light commercial buy light commercial. Attempting to morph hobby grade systems into commercial use is a recipe for disappointment (and...
Belts are fine for cutting soft materials. The key is properly sizing the belt. For that kind of length I probably would not go less than a 15mm...
Realistically no. While some have had success meshing the metric 80/20 sizes into the OpenBuilds as supporting structure, attempting to mesh the...
That gantry plate can be used with 4 or 6 wheels. You will need one of them to have an eccentric spacer so it's best just to ask the shop to price...
There really is no actual number on these wheels and the reason behind that has to do with load vs. longevity. You might get them to work at a...
One suggestion would be mounting it with the X-axis vertical that way you only have to counter weight one actuator. A constant force spring would...
The best approach is probably going with the mirror image approach as show in the documentation. docs:blackbox:connect-nema23-reversed-y2...
Sounds like you have both motors wired the same. Reverse one pair of wires on one of the y-axes. This will set one motor opposite which is what...
The parts list is found under the parts list tab above and it should be in the same spot for all the OpenBuilds actuators. Downloading and...
RD, Do you have a specific purpose/use in mind for this single axis?
BlackBox
Yes but the cutting area in the X direction is greater on the WorkBee due to the thinner side plates. Basically a trade off...
A couple of points here. First the IoT system is only good to about 12 Amps. So what you're suggesting may be pulling too much power. The...
The difference is generational. The WorkBee preceded the Lead system by about a year. The main difference between the two was the desire to get...
