Separate names with a comma.
Some features disabled for guests. Register Today.
It's a fairly simple with a proper jig... [ATTACH] I would recommend using steel bar stock to prevent the bit from wandering.
The Workbee 750x750 screw drive from Ooznest probably offers the best size/form factor that meets your requirements. Ooznest also has excellent...
Shouldn't. The connections of the 20x40s will keep the 20x60 upright and square. There is enough adjustment in the connections that if you shim...
Lay the lengthwise 20x40 supports flat and cut the board short enough to fit between the end rails. Just be sure the 20x40s have proper support in...
Yes and yes but no reason to raise the lead screw to the space between the gap. Keep it as low as possible as this keeps the force close to the...
Two points here. You should be able to get a fairly good idea on what's possible from a number of other systems. A 1000mm gantry is a 1000mm...
Sale doesn't start until midnight EST.
It doesn't work that way. There is no specific "maximum" weight, no set line you cannot cross where one side is good and the other bad. It's more...
Too heavy. Will lead to too much torsional flex in the gantry beam.
The sale hasn't started yet but when it does the discounts will be automatic so no coupon code is required. The circular can be found here. Sale...
According to the sale circular, yes. But it only indicates 15 with the free xPro card. Don't know how many are available beyond that without the...
I believe there were only 50 allotted for the pre-sale and I'm guessing you were #51. You might try again at midnight when the next batch hits.
I'm guessing he bought the 20x60...
Hard to say without knowing how much is needed. Start with the next drill size up and go from there with the intent of trying to keep the enlarged...
Enlarge the non-eccentrics.
Yes, that's the approach I was thinking of. You'll also need to add to those 3 pieces a 500mm section of lead screw. Yes. And the short gantry...
In the past extrusion has been 10% off across the board. I would probably expect the same this year based on the "Low as $2.96" price noted. $2.96...
[MEDIA] Starts about 1:29:40 Board size is on the main build page.
Free shipping over $99. (It's right there at the top of the ad.) As far as discount, I don't know as I'm not an insider but it'll be less than...
If you have the time it would be greatly appreciated if you could post a writeup on these in the Projects section of the forum. I think a lot of...
