Separate names with a comma.
Some features disabled for guests. Register Today.
I think its a mistake to leave it there but its your machine.
Should that be P300 Peter?
You can copy one subheading at a time by holding down left mouse button then scrolling down to select entire subheading, click copy, then paste...
Also upgraded the Z axis during the process What upgrade was that? Is there something to use to help mitigate the problem I am having? Use a vac...
Gruesome.:eek: but also nice!
Yes
If you load a file into Netfabb, its very easy to scale a model
Well, you don't have to use a probe to set Z zero height - just jog Z to lower the axis until it just touches the spoilboard then click "set...
The original poster hasn't said anything about using A4988 drivers on his new build or his current machines or even if he had them - what he did...
Hi Gary, greetings from over the ditch. What are your Nema 23's rated at? 185 oz-in perhaps? If so, they will do the job I'm sure and they are...
If it's an 8mm 4 start Trapezoidal lead-screw, I would expect it to move 8mm per revolution. Also, your steps per unit (if it means steps per mm)...
Do you have pull-up resistors installed for the limit switches to the Arduino?
Have you looked in UGS diagnostics to check if homing is enabled in the firmware? (maybe 2nd last setting - "settings: is homing enabled"
I use button heads because of their deeper hex sockets but anything can be used, even hex bolts if need be. The only consideration is making sure...
Have you checked youtube?
Yep, all good Robert, thanks.
Hey Robert, is there any chance you could save your sketchup files in either version SU 17 or SU 8? Cheers.
This all happened after you re-routed all the wiring so the fault may lay there somewhere. You could try disconnecting all cables from the black...
You were cutting to a depth of 5/8th" in aluminium with a plastic motor mount?
I see you have "flat depth" setting enabled in V carve? Have you tried it without that?
