Separate names with a comma.
Some features disabled for guests. Register Today.
In V carve pro for example, you have a V carve / engraving toolpath for such jobs. Does the software you're using not have such an applet? To...
This is how mine is done... Note that the Y motors and lead-screws are removed to allow the frame to completely stand on its end.
I think he's describing a parallelogram shaped frame (could be wrong). If you remove the spoilboard so you just have a bare frame, then you can...
If my job needs a tool change, I just make separate files for each tool. (Is that what you're getting at?)
It's not that difficult. Modify the settings in the chart above to suit your bit. As a guide, set your depth of cut to about half the diameter of...
There are probably many of us that do not use homing at all, although as Peter points out, it does have its uses.
This list seems to be quite popular - seems to relate to 1/4" bits but is a good ballpark list. [ATTACH]
Have a look at my build log below and scroll down to "Lead-screw Mod and nut blocks", dunno if that helps? Workbee "style" 1010 cnc
You said you have a Chinese knockoff 1515 - what did you need to buy from OB?
I would start by unplugging the switch wires from the controller, then stick a (ohms) meter across the terminals of the switch and see what you...
I think button head screws would be a better solution.
How is the cutter _supposed_ to move from it's initial position to the beginning of the first path in the file? Once you've "set zero" with the...
What do you mean by that?
Have a look at my build - you will see I made extensions for my leadscrews to add length but you would need to make or have them made on a lathe....
23.9 is correct Schwipp
I had a feeling your drivers were OK, but couldn't put a finger on the reason even though I'd seen it before so well done Sam!
Can you upload the DXF file?
I assume you have already factored in the possibility of loosening the router clamp and raising the router itself? BTW, I hope its the camera lens...
I would say that using calipers on a hole that small is unlikely to yield accurate measurements. A hole has round edges edges, calipers have...
I would have thought that most if not all vac hoses had a sprung wire spiral sandwiched in-between a plastic skin cover as part of its "flexed"...
