Separate names with a comma.
Some features disabled for guests. Register Today.
Good point. So maybe more trouble than it’s worth then?
Excellent. Thanks for the confirmation.
Still deciding which way to go for my C Beam Build (Workbee / Sphinx). Either will be 1000x1000 so the same question applies to both. Is there...
Hi Ryan, Thanks for the offer :-) Currently awaiting my brother bringing me his xPro V2 and 24V power supply so I can fault find by...
I presum Ryan is referring to the the current setting pots on the CNC xPro. Turn them to full then back off by 1/8th of a turn for optimum...
My thinking is if it was the xpro it would more than likely just affect one axis. This is affecting all axis to some degree hence my assumption...
Yeah Gone through the full setup for the xpro At the lowest setting they just whistle and don’t move (as expected) But all the way through the...
No dice Disconnected everything and remade all connections. Made sure volts were right (dead on 24v) Steppers still seem ‘weak’ and if you...
Will report back later :-)
Good call. I'll do this later. However i am suspecting the PSU as i can manually 'stall' both x and y with minimal effort The cold weather may...
Bit of a strange issue on my ooznest at the moment Its not been used for approx 4 weeks and this weekend is the first week back cutting. Over...
Looks like it will be an interesting project, keep us all updated :-) Chris
Yeah. Bit cold in the workshop yesterday! Need the extra Z as I’ve been running with approx 3mm spare after 5mm safe z height. Rotating the...
Treated my Ooznest Ox to a full strip and rebuild over the last couple of days. All belts replaced. Spoilboard supports rotated to give more 'z'...
Sounds great. It’s the water cooling that puts me off as it’s just another system to maintain etc Out of interest which have you got?
Will have a look, thanks. Do you use one of those?
As titled, I'm looking for a quieter, affordable, spindle for my Ooznest Ox. The Kress is very good, but noisy! Ideally Air cooled (One less...
Hi Ryan, Whats the lead time on the Ox-Workbee conversion kits. I've been procrastinating way too long over the decision to 'upgrade' from a...
An 'advantage' of belts is when a cut job is finished, you can literally push the gantry away from the workpiece by hand, and conversly when...
Thanks for the prompt reply Ryan. I have seen 12mm leadscres with matching endplates on another site, hence the questioning, but am unsure as to...
