Separate names with a comma.
Some features disabled for guests. Register Today.
Don't be too anxious to get started - it sounds like you need to learn a lot more before you press that "Start" button. Replies to your OB...
I think it should be mentioned here that laptop USB ports can cause connection issues when they've had multiple insertions - everything from an...
Yes, I wondered that - I'm guessing its Polybutadiene or more likely vinyl.
Hey Daniel, don't know if you have already but they have to be cooled. I have 4 fans on mine - one for each driver.
My 6600's receive 32v from the power supply which is the recommended setting for the drivers I believe. They work just fine.
No not you Daniel - I was referring to the original poster Delco.
But you said you had this problem in your first post when you were using 8825's.
Well, should be OK, just check their position on the C beam v slots when assembling. Maybe also let ooznest know what you found.
There's a shim fitted in the centre (between) the bearings - almost sounds like some have 2 shims in there by mistake. You definitely don't want...
I use the uncased 6600"s and they perform perfectly well - not to say there may be bad ones about though.
Maybe worth swapping the slave driver with the X to see if problem changes?
I originally intended to use 175 oz motors something like you have, but upped them to 270 oz in case I wanted more power for a future build....
Yes, important question Icefox because some straight flute bits do not have a full cutting edge across the tip - those are side entry only. Giarc...
It's published but unfinished. Will take another look later, thanks.
Oops, can't find anything down at the bottom?
Thanks Peter
Does anyone know the procedure for removing a build from the build list?
Assembling Your WorkBee
I have my X motor on the right also.
Ok but can the motor plugs be reversed? Disconnect power first!
