Separate names with a comma.
Some features disabled for guests. Register Today.
This kind of construction is extremely strong, certainly if you use an inner and outer shell. The form can withstand very high wind speeds, but...
This is my workshop, still under construction though, but it gives an idea. Dimensions about 20x8 meter, effective workspace about 7.5x10 meter....
Yeah the Hitachi's are pretty good. At the time they didn't have them here in Thailand so I choose for Makita. Next time I probably would go for...
Digger, you're dead on with you comments about the miter saws. Couldn't have said it better. I use mine also mainly for woodwork with monthly...
Sorry to say, but a sliding compound miter saw might look good, but is less accurate than a good quality miter saw (the ones without the...
Are you still talking about the Z limit switch? Here's what I think about it. Lets assume I set the limit switch so it will trigger 3mm before my...
Good to hear it went OK, Martin. You used the A and B end caps I assume? Do me a favor and post some pictures of the installation (here or in your...
Got the electronics worked away in a box and still need to do some finishing on cables (hide/protect them). Tomorrow is the day for getting the...
Thanks, Gray. I don't like the cable though. Probably going for a thinner one and try to figure out a nice 3d printed object to protect the cable...
@ Rhinofart, picture of my limit switch on the Z. [ATTACH]
You're welcome.
Amazon, toggle clamps.
Well, whatever. Something is twisted, that's clear.
Unlike some, I'm willing to listen to advice. I can see your point and it is very likely to happen one day (Murphy lives here at times). So I will...
Hope this picture will make it clear to you why your X should be square with the Y and why 1/2 inch difference between right and left can cause a...
I needed only 1 limit switch on the Z, the one for the upper position limit (since Z0 is the table, don't need a limit switch for that). I've got...
From the user manual? Man, I looked and looked for documentation for this board and didn't manage to find anything. Thanks so much for this! I...
Given that Serge stated before that his gantry is not square (off by a couple of inches!) and looking at the video it seems to be that the...
Ay! And how should I do that wiring? Do you have any picture/example for that? Would be much obliged.
David, thanks for the reply and the excellent explanation. I had separate drivers, one died, for now it's 2 steppers on 1 driver until the new...