Separate names with a comma.
Some features disabled for guests. Register Today.
Thank you sir :) Been watching you rework idea...that will be the next upgrade! Also did the double wide gantry plate.
Decided to go for some upgrades with the sale going on. I'm going to use a double xlarge gantry plate how do I figure out the spacers for the...
Looks like your cut speeds are set to 1.3 mm per minute. If you look a few posts back you can see my settings.
Joe I will check out you suggestion on the line. A single flute would be much better but the double was what I had on hand. I have a SuperPid...
Using a Dewalt DWP611. The bit is specifically for aluminum and have had it for a long time but never used it. It is a .25" two flute. I got it...
Climb cutting with .25" bit at 2000 mm/min at 16000 ish rpm and .15mm step down at 10 degree and 40 mm/min z speed.
Was able to do another run last night. 1/4" bit @2000 mm/min, 16k on a half burned up router, proper tab and cuts heights. At 0.25 mm cut depth....
This run totally dry doubled the speed to 1800mm/min set depth of cut to .25mm and z ramping to 15 degrees. Only issue I ran into was made my cut...
Ideally I would like to get the feeds and speeds correct enough so I could go with no fluid whatsoever
It's a two flute designed for aluminum. I want to say is a 30 degree helix. Can take a pic later of chips and bit. A little oil may help from...
Yes they were dry. That would be my preference to cut dry in my situation. So maybe less depth of cut could solve it?
Here is a pic of what I am seeing. I'm not talking about the tabs or the fact I didn't cut all the way through.
For the most part it looks like a lot of chatter worse in some areas better in others. On this run there was one spot the tool at into the...
As low as the Dewalt dpw611 will go. Says low speed is 16k
So I'm finally cutting some aluminum. I'm using a 1/4" bit and have gone and tightened all my axis up which was part of my problem in a previous...
Ramping ?
If you changed your microscopic you also need to change your steps per mm. I don't use that board I but if the pots are for amperage I ran long...
Sorry for the double post. But to update about the issues I was having with the chatter on cuts, I went and took the z axis apart and gave the...
Just to clarify...the only time you need the extra shim is when you are using the mini and the larger v-wheel together. It may seem obvious but I...
Once I re-tighten the v-wheels I am hoping they should stay set this time...correct?
