Separate names with a comma.
Some features disabled for guests. Register Today.
Yeah, check out youtube and search for xbox 360 controller and bcnc.
I think you can interface one of the game pad style controllers to some of the control software. Like bCNC, I think.
What machine?
That's why I went with the gradus m1 pro. I could replace the drivers if I fried them. They fried pretty easily but were easy to replace.
I screwed up the wiring on my Gradus m1 pro and wired both y motors the same way instead of flipping one. The two motors fought and the near motor...
Pick a side. Watch it intently and move the machine around. It is almost certainly slipping. Mark the pulley so you can see that it is moving...
Have you checked the movements? Like move x and measure x? Move y and measure y?
"Built to go fast and light." You are aware you're making this out of granite, right?
How is it failing you now? What would you like to do with it that you can't?
NC, I believe. That way if a wire gets pulled or breaks it will trip.
The wobbles, I should think.
Thanks for the link to the build!
Mostly working with hard woods. There are a handful of bits that I can only find in 1/2" shanks I'd like to use for leveling. Slow going and very...
Any suggestions? My current setup is a 500w spindle from aliexpress. For what I do it seems okay but I take tiny bites with it and its chuck is...
Doesn't $H run the homing cycle?
G28 sends it to home. $H should run homing.
Make sure you're actively cooling the bigfoot drivers. They fry at the drop of a hat.
Good point. I've some ideas for that. The thing with this idea is that I'm hoping to add strength by creating the sub-frame under the current...
So I'm thinking of doing this. Moving the 8020 y axis supports to the edge just outside of the router body. Then make a 2040 frame underneath...
I will use that as a checklist to go over my setup. Thank you!
