Separate names with a comma.
Some features disabled for guests. Register Today.
I spoke with Gerrit and he put a a new zip today with the missing files. I will be trying this later today.
I took them from the .17 files that I had. Not saying its right, but I was able to get it to open in the interim.
I got it to work, there are 2 files that are missing. I'm not home at the minute but one is the config and one is a button file. The machine is a...
Any luck in getting .18 running. I can't even open the .exe on two separate computers.
Finding bellows is difficult, I've been looking for solutions for both the linear rails and the ballscrews.
I'm currently upgrading to dual air nozzles!
Nice job Michael. I like how everything turned out. The size of the plates mean nothing to the capacity of the machine, I'm speaking in terms of...
Machine really has been great so far. I've made updates from this build but overall no real changes to the design. Everything had been very solid....
Hiwin book if needed, page 32.
Just to give you the bad news, based on your measurements, I am going to guess these are Series 15 rails (15mm). Those actually use M4 Bolts, not M5.
I would try to find the bolt at McMaster Carr in the States. They will at least give you an idea of what is out there. Just so you know, each...
I'm sure you will be fine. That motor you were using isn't going to be enough to hold. You should be fine now.
If I was doing this, here is what I would do if I wanted a really clean looking part. Using a 1/8" endmill, I would do the following: 1) Machine...
In short tramming the spindle is adjusting the spindle so that it is square to the table at all sides. What I like to is take a 1/4" steel dowel...
While everyone is recommending surfacing, you should consider tramming the spindle in as well.
So did you check the shaft coupler, those can work themselves loose. I too second going for the mechanical side.
I think you're missing my point. It is possible using ugs, but not with grbl panel.
Interesting observation regarding grbl panel. I have noticed that when making very small moves, .01mm, the DRO will change but the machine doesn't...
1) Do you really need to use 1/16" endmills? That is probably close to impossible to learn on. The smaller the endmill the more on the money...
My machine is a bad example to most, in the sense that I have a significant amount of weight in the machine which lends to the rigidity of it. I...
