Separate names with a comma.
Some features disabled for guests. Register Today.
Ooznest have re-designed their Workbee now so the leadscrews (overlength) are under tension - bearings and lock collars on the outside. Tension is...
I have a workbee rather than a lead machine, but Ooznest recommend (for earlier versions of their machine) slackening the screws holding the Y end...
As Marconi discovered, an arc (spark) emits radio frequencies. Alex.
You would be asking a lot of the standard motors if you wanted them to raise the whole X axis as well as the Z. I asked Ooznest this question when...
How did you identify which wires were connected to the stepper motor coils @Xamer ? This thread might help with the wiring; Stepper motors won't...
As @Giarc said, also have a look here; Stepper motors won't turn Alex.
Are you connecting your stepper motor directly to the Arduino? - that won't work. If you are using a stepper driver which one, and do you know the...
Hi @Colin Hart , when I calibrate my machine I use the pointiest tool I have. I don't actually cut - I have the tool about 1mm above the...
Hi @Colin Hart , I don't follow your spreadsheet. In cut 1 did you have steps/mm at 400 and get the result shown? Then in cut 2 did you have...
Increase $27 to (say) 10 to see if that helps. If it does decrease it until you get to a value that reliably works. Alex. Also if you set $20=1...
PS, @Mark Bullock , your design may not have any curves, but your g-code may still contain arc commands (G2/G3) as your toolpath may include a...
No, you didn't change anything in the Duet firmware to enable grbl. It's all g-code, but comes in different "flavours" - basically a selection or...
What post processor are you using? You should be using this one; https://ooznest.co.uk/wp-content/uploads/2019/02/Fusion-v1.0.1.zip Alex.
Yes they do - like anything to do with Fusion there is a learning curve, but I mostly use Fusion and like it because (for the simple jobs I do) I...
I can't help with the Open builds cam question, but why are you not using the cam functions (manufacturing) of Fusion? Alex. PS that was a...
Another common problem is "my steppers keep reversing direction, or just sit there making a noise" This is almost certainly (99.5% sure) one of...
