Separate names with a comma.
Some features disabled for guests. Register Today.
Could I ask you to post this in Resources where more people are likely to find it? Thanks, Alex.:thumbsup::thumbsup::thumbsup:
I won't comment on all your post - there are other people on here much more familiar with the black box than me who would be better able to...
Ahh - depends on the make of the flexible coupler - some have a screw which compresses the coupler onto a shaft - mine have grubscrews - two of...
I tested it on a test piece I'm using for my own experiments - face, pocket and contour. I'm heading in the opposite direction - one nc file...
Let us know how you get on @Matt Thorniley. Alex.
It's a bit late to say this now (unless you want to dismantle bits of your machine) but the nut blocks are usually tight when new and the advice...
Works like a dream - I didn't realise you could/had to specify a tool number - just found out how to. Alex.
Hi @sharmstr, I just had a play with your post processor. I'm probably being stupid (won't be the first time:D) but I thought the idea was you...
Thanks @Peter Van Der Walt, finished lunch now. Alex.:D:D:D
Hi @Matt Thorniley, I'm on my phone at the moment and about to have lunch, if someone else doesn't give you the info you need before me I'll give...
What post processor are you using with Fusion 360? I haven't checked all your G code (its a long file), but you have tool changes in there which...
I believe that in the Duet Web Control you can increase feed rates while a job is running - courtesy of the rep-rap firmware that allows you to...
Yes Peter - my bad - I didn't read the post properly. Sorry!:oops::oops: Alex.
See post #369, page 13. Alex.
I use (cheap Chinese) V engraving bits for jobs like this - 10 degree angle 0.1 mm tip diameter. They are a bit more robust than a 0.1mm endmill....
I'd really like to be able to do that with my workbee, but the Fusion post processor for the Duet doesn't generate line numbers. Alex.:(:( EDIT;...
To answer a couple of your points (I have a 1000*1000 workbee by Ooznest in the UK) I can't do a direct comparison but see a lot of similarities...
Indeed @GrayUK - an awful lot of critical testing happens AFTER the event that highlighted the need for it. Alex.
I am not aware of a manual for the workbee with duet controller - although the wiki for the duet is useful it is important to remember that...
On PAUSE it is supposed to homeall (ie go to limit switches) - on RESUME it should go back to where it was when you pressed PAUSE and carry on...
