Separate names with a comma.
Some features disabled for guests. Register Today.
Yes - I and @Colin Mccourt had this problem too. @Ryan Lock acknowledges this has been a problem and says that it has been dealt with. It can also...
Very nice. Interesting optical illusion - zoomed in on your "chalet" picture and sometimes the text etc looked recessed and sometimes it gave the...
Not knowing where you are based it is a bit difficult to recommend a specific bit. I tend to use cheap router bits from the likes of screwfix and...
Interesting, I did draw this problem to the attention of Oozenest - I wonder if they have changed the firmware? Though if your config.g still...
What cutters are you using? Unless I need a really small diameter bit I use router bits for cutting wood. Up-cutting milling bits would tend to...
That's the one! Thanks @sharmstr. Alex.
Hi @hobdayd, I just checked my config.g - the M564 line says H0, but I can't jog my machine without homing first and my soft limits work - I can't...
I don't know - I didn't mess with any code - just unticked the box in Duet web control which fixed the problem. Alex.
No, it's a setting in Duet web control - first screen in settings I think. You may have to save changes after unticking it. Alex.
Interference? Have a look at how your cables are routed to see if you can keep your spindle cables away from others. Alex.
Hi @Colin Hart - can't work out how to link to it using my phone - it is "Workbee with duet controller" - will try to post a link tonight when I...
Hi @Colin Mccourt, did you ever finish this? If so how did it turn out? Alex.
PS - have a look at my build report (workbee with Duet controller) for a few important points about the Duet controller. Especially, Oozenest set...
Hi @hobdayd, this should tell you what to do with the Oozenest Fusion 360 post processor. Post another question here if you get stuck. Alex....
Pleased to hear that it was nothing complicated @andreashalim. Invest in some hold-downs? :D if you have access to a 3d printer I can give you...
Hi @andreashalim, could you post your Fusion 360 file (the one with two separate toolpaths) here. Alex.
Spacer plate for X axis drag chain now in resources/parts. Alex.
The X axis drag chain on the workbee is very close to the wire for the Z limit switch. This spacer moves the drag chain 3mm further away from the...
Alex Chambers submitted a new resource: Spacer for Workbee X drag Chain - X Drag Chain spacer The X axis drag chain on the workbee is very close...
If you go to settings in Duet Web Control there's a box (on the first screen I think) that says "allow moves without homing" - it needs to be...
