Separate names with a comma.
Some features disabled for guests. Register Today.
Grbl Settings tab scroll down to Homing Cycle and set to 1. See Grbl v1.1 Configuration (click on link, takes you direct to correct section)...
Still doesn't seem like us (no other complaints in all this time) So for the sake of trying to replicate, lets get latest Grbl Settings backup,...
Coordinates are not calibration affected. Real world distances are. Calibration sets the difference between theoretical distance in steps per mm...
Nobody stopped...? Did you click the link in my last post before this reply? It takes you directly to the revelevant Grbl Setting item in the Grbl...
See Grbl v1.1 Configuration Though if you followed earlier advice You could use the big old Limit Switches Installed switch right next to the...
Yes, see
Just making sure we have the latest to see what you have... Will check and get back to you, no other changes in this time, still all switches at...
Start with a good profile, then customize from there (nearest similar machine) Read all of the Grbl Wiki - knowledge is power Grbl v1.1...
Our High torque motor is a little slower than NEMA 23 Stepper Motor - our standard motor for our machines. Balance of speed vs power is up to...
So ours with lower inductance, will have higher top speed before stalling. Higher inductance = higher back-EMF, which exhibits a self-braking...
Check that your motors electrical specs are similar to ours. 3V Coils, 1-2mH Inductance, <3.2A Max current. Whining noise is stalling, can...
Sample file and Grbl Settings backup for review?
Did you remember to load a machine profile? CONTROL > Grbl Settings tab > Select a machine from the list > Save and reset when prompted Or you...
Could be runout on that "DC motor with a collet adapter pressed on" (those motors doesn't have sufficient bearings to be called a spindle)
Actually 10 or 11. Even 7s been end of life for years Microsoft Windows. XP has been end of life for 16 years :) Yes stored in EEPROM on the...
And yes, please use the correct Post Processors (not related to soft limits issue, but still good practice) docs:software:cam [OpenBuilds...
Right, so [ATTACH] Keep in mind (or if not read yet, please do Frequently Asked Questions ) that the entire machine lies in negative quadrant...
Yes, you should be using CONTROL. BlackBox is far more modern than the old Grbl/UGS workflows Learn more at about the very easy software...
Digital Read Outs - the numbers that show current position
Negative. Hover over the DROs themselves to see the Work and Machine Coordinates [ATTACH]
