Separate names with a comma.
Some features disabled for guests. Register Today.
Plugging a 0-10v device into a 3.3v PWM could have damaged your controller. Random wiring is extremely reckless. Follow documentation (and logic...
<offset> = probe + endmill radius so hardcoding an offset - one has to use same bit/dowel for probing then as endmill diameter menu was part of...
Jog to. Click Setzero (: or buy a Probe
Make sure to load a machine profile from CONTROL > Grbl Settings > Select a machine from the list, save and reset / OR/ make sure you have PSU...
Ok, so you would have to reach out to Carveco support and ask them how to edit in a spindle start delay for the post processor, so that Carveco...
$3 sets jog directions (set to match cartesian standard) Then use $23 to tell "where are the switches" - where did you install them. At axis Min...
Ok looks correct, please contact the store via Support > New ticket. Include a link to this thread and mention I sent you. Let the store send out...
Is machine correctly set up? (if not fix directions in Grbl Settings) Does the Hello World run correctly? (or is it reversed) Are you probing...
Best to double check all wiring, if it was working and then stopped it seems to have become damaged there. Are you using our power supply?...
Docs are still valid. Grab one from our store and it will all work (:
Full Grbl Settings backup for review please (CONTROL > GRBL SETTINGS TAB > BACKUP SETTINGS ON THE MAIN TOOLBAR)
You can always ask the store to send you other ones. But a tight one is a good one, i'd rather bed in a tight one than have a loose one. Slight...
Was there any earlier mis wiring events? While it appears correctly wired now, if there was any mistakes best to disclose. Next up: try different...
Your CAM should do that for you. Which CAM are you using to create your tool paths / gcode?
And add a little Dry/PTFE lubricant spray
That just shows there's something specific about yours, or your workflow, or your tooling... Worn wheels, some non standard modification,...
What about https://www.amazon.com/s?k=Garage+Ceiling+Storage+Rack+Lift? Only takes up space when in use then up and out of the way? [MEDIA]
Contact on 3 of the 4 motor wires only: docs:blackbox-x32:faq-identify-motor-coils [OpenBuilds Documentation] - break somewhere along the way...
Yes, losing the extra driver does come with a compromise, totally normal. Less total power available to the motors than if it were two drivers....
N/A - dry contact docs:blackbox-x32:connect-plasma [OpenBuilds Documentation] - plasma inverter's inputs just wants you to close the contact...
