Separate names with a comma.
Some features disabled for guests. Register Today.
Usb cable is unplugged? And with USB cable unplugged all the usual LEDs on BlackBox still lit?
Or incorrect taper in tool setup. Make sure angle of v bit matches angle specified in tool library
The dimensions you enter are the size it will run. So yes, determine how far it is you want to surface in each direction and enter that. Overshoot...
Reset while in motion means something shorted out the controller. Recheck probe wiring. Check that spindle body isn't shorted to DC GND as well
Make sure your gcode contains the coordinate system in its header.
You may need to customize a post, I don't know of a Vectric post that supports A yet (wrapping was more for X/Y wrapping) - but might be better to...
Access denied means port already open in some other application (conflict) like EaselDriver. One allowed at a time. Close conflicting applications
Have you tried connecting yet? CONTROL will work with any standard grbl/grblHAL based controller. So unless it runs 3rd party/proprietary firmware...
That's part of why we never got round to it either. Messing with gcode in realtime is really really hard. You got to break up long moves and arcs...
If it was one of those far east XL4005s they often fail in the worst way. Letting full input supply voltage out the other end. Hook it up to psu...
Use the Troubleshooting tab to test and logs of a probe attempt for us to review. Possibly an Earth to DC GND short via a spindle body, if probe...
CONTROL > Grbl Settings tab > $3 Direction Invert > Flip the Z Axis switch the other from where its now. Save and Reset when prompted
If your Z axis is reversed, correct it in Grbl Settings. Z+ should raise the tool off the stock, Z- should bring it toward the stock.
Thanks. Please contact the store via Support > New ticket for further assistance
Please post a Grbl Settings backup for review
And Tensioning system, thinner endplates etc. Else will have issues with whip.
Double check that on the far end of any extensions too (So measure A+ to A- across the extension's one leg, through coil, out the other extension...
Motors never go bad. Its always wiring. If joints look good, on a older machine cables can have breaks inside insulation (constant back and forth...
Yes as mentioned and later
Click connect, watch log scrolling by (Or send $I): 20240402 is latest included in CONTROL (For even newer you can use grblHAL Web Builder but...
