Separate names with a comma.
Some features disabled for guests. Register Today.
I have not yet upgraded to V 12 of Vcarve so I can't open that project. Did you cut out the board, or was the board pre-cut? Was it slightly...
It is probably M2 or M3. If it were me, I would not replace it with a grub screw. I would replace it with a socket cap (if there is room. That...
I have used a 12 foot USB cable for 8 years with no issues. But it is just a simple CNC Router, not plasma. The cable runs well away from...
What kind of sensor? If inductive, is it PNP or NPN? If you are having issues, microswitches are easy, cheap, and accurate.
I run 1 meter on a 1.5 meter axis. I just mount one end to the tool head/Z axis and the other to a point on my support piece the chain is fastened...
If it is erratic, then you may have a loose wire in you z Stepper cable.
I use one Y set of wires because the rotary axis only has one stepper motor. You need to unplug the other Y or that side will try moving when Y...
If using the Demon Post processor as is, you could use either. But disconnect both from the Y steppers or one side will try to move. That post...
Yours appears to use Openrail mounted on the extrusions. Here is that product page. There is links to assembly directions. That may help. OpenRail...
To get a good accurate calibration, put a pointy endmill like a V bit in and jog it at the longest distance you can next to a measuring tool. The...
That appears to be a custom built machine probably from before their were OpenBuilds machine kits. I would maybe take photos and sketch the parts.
Did you install the drivers as per the documents? docs:blackbox-x32:install-drivers [OpenBuilds Documentation] Did you troubleshoot the USB...
Earlier, I read your post that you deleted. Just getting around now to trying to help. 1) Have you homed the machine before doing anything job...
Start with that, but recalibrate the axis that you changed.
""
You need to calibrate your steps/mm (or inch). If using Openbuilds Control, it is easy and it is built into the software. [ATTACH] I highly...
The images you linked to show them wired as NO (Normally open). Only the NO and Common (aka ground) are hooked up. [ATTACH] If wiring NO at both...
Maybe a break in the ground wire that is not apparent.
If it is truly for an emergency, place the E-stop on the main power to your machine so if a true emergency happens, all power is cut. I have used...
Can you upload the gcode file for us to look at? Have you ran it in a gcode simulator to see if it looks like it should work? Here is a simple...
