Separate names with a comma.
Some features disabled for guests. Register Today.
That is so cool.
I was thinking the green light. My bad.
I have been having a lot of fun drawing large things with my newly rebuilt and enlarged CNC router this weekend, and and finally getting around to...
Then it appears the probe is working That is correct. You are not closing a circuit by just touching one or the other. The magnet needs to be...
Did you install drivers for the Arduino? When you download the Arduino IDE it installs drivers I believe. https://www.arduino.cc/en/software If...
WHen you say you had X and Y, but no Z, were you able to control the X and Y? If so, did you perhaps flash the two axis laser version? If you...
You may need to run a ground wire through your dust collector hose. It may be creating a lot of static electricity leading to EMI.
Are you connecting the wires directly to your controller? Or using a plug? If it only takes the two wires and you are using blue and black, it...
Have you tried flashing it with the OpenBuilds Control software? Or were you using the Arduino IDE?
You need Black and Blue. Blue is signal, Black is ground. Red is for power for the LED if you have a three wire....
If using inches, then yes. Also use the OpenBuilds post processors for Vectric. docs:software:vectric [OpenBuilds Documentation] Also, I am...
He does not mention them, but yes they are listed onscreen. I believe he mentions the nut blocks were already attached prior to the steps which...
How are you trying to flash it? I recently flashed a knock-off Arduino nano I had lying around to test some limit switches and I flashed it with...
When you say "original" do you mean the actual official Italian made Arduino? Arduino Uno Rev3 I flashed one in 2016, then updated it when...
Also, check to be sure your wiring is correct. docs:blackbox-x32:faq-identify-motor-coils [OpenBuilds Documentation] If it is not an OpenBuilds...
How did you create the gcode for your job? What feed rate did you specify in your CAM software for your cutting tool? For example, when I...
I was able to access it. I used the 3D models for these blocks from McMaster I believe. Here is my Z axis. Blocks and spacers for the lead screw...
I used aluminum angle mounted to existing openbuilds plates. I have all the files. For the Z I was able to use the nut block with the existing...
Bearings work fine. I just rebuilt my original CNC using a LEAD High Z kit then modified some plates for linear bearings and I have not seen an...
Is it traveling slow when cutting, or when you are manually jogging it around. If your maximum feed rate in the GRBL settings is low, then it will...
