Separate names with a comma.
Some features disabled for guests. Register Today.
Everything will be cut inaccurately by a factor of 4. You should read the GRBL wiki so you understand what each setting does. If it moves slow,...
Error 9 is a homing cycle error or something is causing your machine to believe the limit/homing switches may have been triggered. GRBL isn't...
Sadly that is what inkscape does. It took me a while to figure that out when I would import an .svg into Fusion 360. Now what I do it go in to...
It is definitely a better probe. I have the older model that had no corner cut outs which is why I upgraded.
You could get the XYZ probe and just not hook up the 5 volt line. It will work. You will only be missing the light indicating the endmill touched...
Contact Us
Those were items he downloaded from here: PRO Rack and Pinion Drive, NEMA 23 | Avid CNC I believe some of those parts were purchased.
Surfacing the spoil board creates a lot of mdf dust which can produce a lot of static electricity.
Are you re-zeroing X, and Y between ops? If so, that may be the problem/part of the problem. You only should re-zero Z between operations. The...
What machine is it used on?
It sounds like it is slowly loosing steps over time so the longer it runs the more inaccurate it is getting. Are there and loose screws on...
I want to see this thing in action. It looks great. Estlcam is an easy to use program that will do a ramp at each pass of whatever angle you...
You plugged a new motor into the old cable which probably has a short in it. This is just a suggestion because if the motor coils are not paired...
Did you turn Hard limits back on? I believe you need that for homing
Either switch one pair of the wires around on that stepper motor, or use the software to invert the direction. It is easy in the OpenBuilds...
You need a 12v power supply and it needs to share a common ground with the Blackbox like the Blackbox documents show....
I have a cheap k40 40 watt and it cuts acrylic very well. However, I do not believe it will do 6mm I. One pass unless you go real slow. It does...
A CO2 laser will cut both. Not sure on the power needed for one pass. My 40 watt C02 does it in about 4-5 passes, but I am cutting at a speed...
I assume that was for a Y axis where it was causing the gantry to rack. If not, you can easily change directions in the grbl settings. You can...
