Separate names with a comma.
Some features disabled for guests. Register Today.
Yeah. Those are two 5 watt lasers combined with mirrors. I looked at some of those at one point and I realized I could get a separate 40 watt CO2...
The Blackbox would be a real simple solution if your power supply is 24V. Or buy a 24 V Meanwell power supply along with the BlackBox. Do you...
When you say you used the 0-10V pwm, did you do this? docs:blackbox:connect-vfd [OpenBuilds Documentation] Or did you follow these instructions?...
I am wrapping up this modification using OpenBuilds parts and using a grbl based controller to run it. I just need to gut the blue box and...
I just had this issue on a new Y table I made for my LEAD lathe so I can run it as a normal CNC. It was only one one of the two linear actuators...
I have a slight wobble in mine too, but I was able to go back over some writing a second time with no issue. I figured that the wobble should...
I did one of the pen holders out of ABS. In fact all my parts for my build of your dedicated rotary laser are printed from ABS. I have a ton of...
The acceleration is how quickly the stepper motors spin up to the rpms necessary to move the gantry at the feed rate you told it to cut at. It is...
You were cutting at 4572mm/min (180 ipm) That is very fast. For most woods, I started with 100ipm (2540mm/min). Why that number? It was the...
What are the default speeds and speeds? Those are based on certain factors and may not be right for your machine.
That looks great. I love the table it is mounted on.
How deep is your initial plunge? The reason I ask is that I have flex in mine as well if I put a lot of force by hand into it (loosening the...
I like it. My wife liked the one you shared that went out 100 places.
It is probably running in reverse so the endmill is not cutting properly. It should turn clockwise.
There may be a short/loose wire. I would check all the connections to start with for the troubleshooting process.
All the relevant videos are here: OpenBuilds Workbee 1510 (60" x 40") These videos should apply of it was purchased from OpenBuilds or an...
Out of curiosity what was your stepover percentage?
It probably may be the limit. A 1/2 inch end mill is removing 4 time the material (roughly: twice the width and twice the depth since you were...
Is it MDF? It is very dusty, and on the rare occasions that I have cut it, it is static prone.
An issue I see, is that you need an extra long endmill to cut through 1.5" material. The longer the endmill, the more flex in the the endmill...
