Separate names with a comma.
Some features disabled for guests. Register Today.
Here you go. I have this manual bookmarked....
If you're want the simplest to use with a lot of tutorial videos, VCarve Desktop is an easy to use and very powerful software. Especially if you...
Now if only I could buy one here in the U.S.:)
Actually, the Grizzly is a cheaper version of the Makita. ;) The Router11 has higher quality bearings and is designed for the ER11 collet. You...
I added an Enclosure to my CNC Lathe to keep the chips from flying everywhere and to get the doors to latch shut, I designed and printed some...
Much of that is done by your post processor. I use the grbl mm post processor with Vectric Vcarve and it turns my spindle on and off (M3/M5)....
I measure corner to corner with a tape. Is your hole round? Did you calibrate the x y and z axis? If not, your machine thinks it is cutting 60...
It just dawned on me today, as I was trying to figure out how to carve out the hole for the drink can in a wooden stein like one of these (or deep...
Yes. You are right if I understand you correctly. Six switches would require the two for each axis to be wired in parallel if they are normally...
I had this issue trying to carve a 59mm thick piece and my Z travel is only 60mm. I change the safe z height in Vcarve to 0.5mm, recalculated the...
Just follow these directions and the limit switch install will be easy. If they are the OpenBuilds extension switches:...
If you are buying a machine that is factory built and they are all the same, I would agree. But these are built by individuals and not all are...
I edited a couple things and added to it
1) Spoilboard thickness: What are you planning to cut? If you do not plan to cut thinks much thicker than aluminum plates or plywood, I would...
I have not had an issue with it in the 5 years I have used them. If you use a dust shoe, it will help a lot. I cut a lot of aluminum, plastic,...
You may have a loose wire to the motor. If not all wires are connected it will be jerky and make a grinding noise
McMaster-Carr is where I got some for custom anti-backlash nuts. McMaster-Carr
I have made edge lit engravings with a v-bit quite a bit. The best thing to do is engrave it in reverse on the back side. It will appear much cleaner
Are you using the standard settings in the profile? Or did you up the acceleration?
I purchased one of these and according to my caliper is dead on at 6.35mm. VERMONT GAGE 911225000 Class ZZ No-Go Pin Gauge Tol 0.00020 in...
