Separate names with a comma.
Some features disabled for guests. Register Today.
That is precisely the reason I purchased one of the older OpenBuilds round touch plates. I plan to eventually install it permanently off to the...
I was thinking of doing something similar with a small open bed cargo trailer. I was going to mimic how Bedslide or one of the other truck bed...
You could try to use them and use the Linear Rail - OpenRail® Linear Rail - OpenBuilds Part Store on them, but that costs nearly as much as just...
Great build. Interesting the Langmuir Crossfire deserved to be tossed back in the dumpster. I have seen youtube videos regarding them, but I do...
You are probably right. I guess we would have found out if I was wrong 8.333 hours after the first attempt. :) I have never messed with the G4. I...
That may be to much for one of the onboard drivers on the Blackbox.
I have only found one online retailer that sells both male and female at a reasonable price. You get both pieces (male and Female) for the price...
Did you enter in the machine profile? I forgot to do this the other day on my lathe and I could not get the OpenBuilds control to get it to move...
Just a quick check to be sure and I found GRBL does support the G4. gnea/grbl
Maybe a G04 P(time in milliseconds I think) command after each move? So, unless I am wrong about the milliseconds, you may need a G4 P30000. I am...
He may not have understood that you had 5 motors. 2 for Y and 2 for Z. What amperage are your Z motors?
You may have to wire your Z in parallel (two wired to the Z). The Y carries the most weight so I would use two separate drivers for that as per...
SOMETHING BIG IS COMING!! This is awesome! I will assume that since I guessed right, I won one. You already have my shipping address. ;)
Yup. And it really is not much in the way of components. It is relatively cheap until you factor in the rotary axis. ;) I think it cost as much...
The half of that connection you can't find is where the magic happens. The dimensions are found in the Xtension Connector Sets link and they are...
Or you can do what I did. Count up all your parts, figure out what you need to build a LEAD style machine with the existing parts plus new Cbeams...
Have you checked your spam folder? Sometimes the email servers put it there. It happened to me before.
The chart in the resources section is a really good place to start. That is what I did. Then I dialed in my machine from there. My machine is a...
I pretty much cut all woods at 2500 mm /min, doc is 1/2 the cutter diameter. Same with HDPE plastic. I do not cut much acrylic. For aluminum, I...
There are a couple of builds recently where people joined extrusions to make CCN routers for cutting full sheets of plywood. Here is one....
