Separate names with a comma.
Some features disabled for guests. Register Today.
I apologize, but I couldn't tell if you had these questions in the past, or actually are asking them now. So, if you or anyone still has these...
With an M8 with 1.25 pitch at 1/8 microstepping, 1280 is the steps/mm according to this RepRap Calculator - Prusa Printers But, I do not know if...
I ordered a few of the wheel kits from the "far east" out of curiosity. The shims were not 1mm. They were all less than that. Also, about half...
I like the higher voltage for the steppers, but you are probably right with it not being too much of a load. That being said, my X axis is 1500mm...
Here is how I did it. First, I calculated my steps/mm (theoretical) with my lead screws which were supposed to turn 1/2 inch (12.7mm) per...
I would think 12 volts will be fine. I have a 12v laser, but a 24 v supply. I found a small 12 v power supply with the scanner I salvaged for the...
[ATTACH] I just made the switch to Estlcam yesterday and am about to cut a new 3d printer plate out of aluminum with my Ox variant. I plan to...
Are you sure? The board comes with the default setting of 1/8. With the 14 tooth pulley - which I believe the Acro comes with- at 1/8 you would...
What is your microstepping set at? 5. Troubleshooting · Spark-Concepts/xPRO Wiki · GitHub For your x and y, your microstepping jumpers are...
Cool! That should work.
You could get yourself a block of delrin and make your own antibacklash nuts. I did this for 1/2 inch lead screws and it works great.
Or you could try to use surface scanning with Estlcam.de 2D / 3D CAM Software und CNC Steuerung...
If you are using GRBL read this Home · gnea/grbl Wiki · GitHub All of it...a couple times...refer to it often. I have been up and running with...
For wood, I am generally running about 2500mm/min with a single flute endmill at 10000 rpms. DOC was probably around 2-3 mm.
I used this: https://www.homedepot.com/p/Southwire-500-ft-18-2-Shielded-Security-Cable-57573144/202316266, but I bought it by the foot instead of...
Cool! I made that paddle, too. I used the band saw, table saw, spokeshave, random orbital sander and router table. I didn't have my CNC back...
I was putting together an order over a several day period once, and I lost it when I left it sit for a few days. What I do now is put the items...
This is awesome! I am getting ready to do something similar. I help run one of the largest kayak fishing tournaments on the West Coast (Oregon...
I can answer a couple of your questions. The acro plates have hole spacing for NEMA 17 motors. You may be able to modify them, but they are also...
I can barely hear my Makita at 10000 rpms until it starts cutting (which is usually the speed cut at). Once I turn my vacuum (or dust collector)...
