Separate names with a comma.
Some features disabled for guests. Register Today.
There is no such thing as v slot waste. There are egg-bots that need to be built with those short pieces. It is that time of year. But, to help...
It does look cool!
Oh, I should have mentioned, I use particle board instead of MDF for my spoilboards. It is significantly cheaper and holds screws better (IMHO)...
I have to do the same thing. Now if only I could remember how to do it. I have been stalling since everything was running so well on 0.9j....
Are they the right thread? I did not see where it stated if they were M8 coarse (1.25 pitch) or fine (1 pitch). They are most likely the coarse...
I used this Excel Sheet to calculate Deflection and ultimately decided to support my 1500 mm Y axis the full length. Because of this support, I...
Have you calibrated it yet? If not, here is how I did mine. Lead Screw Driven Ox Derivative (850x1500) Also, see this to figure out your steps/mm...
Thanks
Was it by any chance this one? 445nm 2000mW 2W Blue Laser Module For DIY Laser Cutter Engraver Sale - Banggood Mobile
I like it! I was actually thinking of mounting a laser to the rear gantry plate because there is nothing on it. I figured I would just manually...
There is also Smoothieboard 5xC v1.1 . It has 2 amp drivers on it if you do not need more than that, or it can be used to control larger...
Yes. And on Mac and Linux. GRBL is free and so are the various interfaces. Using Grbl · grbl/grbl Wiki · GitHub I use GRBL Panel on a windows...
Arduino board and DQ542ma drivers. I used a screw shield on the Arduino to make it easier to wire everything up. The Sphinx build has a very good...
Thanks for that tip on Google.com. That should be put in the resources section!:thumbsup:;)
My next build will most likely be a 3D printer, so probably that.
The motors list the shaft size in the product description. If I remember correctly, NEMA 17 are 5mm and NEMA 23 are 6.35 mm. As long as both your...
I hope you do better than me. I can get the photo on the part and extrude the stuff I want and get the tool paths needed. However, it keeps...
I cut mostly wood so I went with the movable gantry like the Ox. The movable gantry makes it easier to cut large pieces of wood. I went with lead...
What do you plan on cutting the most?
I have the Makita and I cut aluminum just fine. The Makita is quiet, especially at 10,000 rpms when I am cutting wood. I cannot hear it over the...
