Separate names with a comma.
Some features disabled for guests. Register Today.
Yeah, I used cutting fluid on all of mine. I also used it on all the holes I drilled and it really helped when I was drilling and tapping into my...
Solved it! Thanks again David. My $1 was 25. It is now $1=255. Configuring Grbl v0.9 · grbl/grbl Wiki · GitHub [IMG]
I am using GRBL Panel and a protoneer shield with drv8825 drivers. I believe I am using 1/8 micro stepping. I would have to verify. I have not...
Thank you very much. I never noticed it until I had the router installed, but then again, I never really paid attention until I was cutting...
I put this in the "motors" forum, but thought I would throw it in here, too: I am baffled. My Z-stepper, upon completing a move up, rotates...
I am baffled. My Z-stepper, upon completing a move up, rotates counterclockwise about 2 degrees-ish. Upon moving down, when it stops, it rotates...
Thanks for the tips. I had it turned down low ( I think 8000 rpms on the Makita). As for cutting faster, I just used the existing Gcode that I...
How often do they do these sessions?
Bragging rights. ;)
I had to travel well beyond the length of the wire that was on the steppers so I bought 18/4 stranded shielded wire for about $0.22-ish per foot...
CNC-July 30, 2016.
Well, I updated the build with lots of pictures today. Also, last night I took the "trouble shoot" gcode file posted here: Tinyg configuration and...
1776. The original Brexit.o_O
I go to a local metal dealer. Doesn't matter what I buy, it is $3 / pound. it costs a couple bucks per cut, but i have been lucky and have found...
No I checked 'overhead'. I am embarrassed to say it was operator error. Everything is set up temporarily with my computer sitting on my belt...
Thanks. I am trying to figure out if Sketchucam is 90 or 270 degrees off from what I expected on mine. For all I know at this time, it is possible...
I designed them myself by modifying the original Ox plates and making them 20 mm taller. I cut them by hand and drilled them on my drill press...
I made plates and I did two 2080s on mine bolted together. Works great. I pretty much have it done and have been drawing circles, squares, and...
I like the 1/2 inch 5 start rods. Mine span 1500 mm and I had my CNC router doing up to 5000 mm/ minute with no whipping. It would be much easier...
