Separate names with a comma.
Some features disabled for guests. Register Today.
When I try to load this in 2017, I get nothing, just a blank workspace. Any ideas? MG
You should be able to generate a parts list from the Sketchup model just by making a manual list. Just go through the model and write down all...
Just wire the outputs on the board for the Y axis to the inputs to your 2 Y axis stepper drivers in parallel, ie step to step, dir to dir, enable...
Well, it's either that or give up completely... Sorry, my blog does not mention the Smoothieware board, but it has lots of info on everything...
Check out my website Blog page: www.3dTechWorks.ca It has most of the info you need. MG
Thanks, Mark. I was hoping you could incorporate some of these ideas into a V2 kit. Contact me if you want to collablrate further on this. MG
Seriously? You just need 4 screws (or 8). Note how the plates are threaded in 4 holes and thru holes in 4 others (between the wheels)? With the...
I use GRBL Panel. Pretty stable and bug free. A lot of people also like UGS. There are lots of them out there, they all pretty much work, just...
Metalguru published a new build: Yet another build of an improved C-Beam Machine, improving stiffness, size, versatility, and strength without...
If I understand your question correctly, you are asking why the anti-backlash nut blocks are not used on the X and Y axes. The answer is that it...
Might be ok, but I'm not very fond of those stepper driver modules. I've used them in the past and they are not that great. I don't like modules...
My current setup is an Arduino Nano on a screw terminal board I get from Amazon. Both cost me a grand total of $10. I have GRBL 1.1F loaded into...
I got this... 14lb 8 oz
Marcus1 I agree with Rob, tabs are meant to be left in place and the entire sheet removed and manually cut out after routing is done. I have a...
Yeah, Yeah, those issues have nothing to do with motors. Perhaps, as Rob said, put tabs on your cuts, another possibility is to cover the back...
I think you may be expecting servos to solve a problem that may not even be motor related. It may be that you are blaming your motors for making...
I did a write up in Prox Sensor Wiring for Limit/Homing Switches that has some detail on how I mount them. Contact me if you have specific...
Well, even the OB mounts use cast corners to hold them on. IMHO Seems like a bit of a backward step to go to the 8 wheel C-Beam Z axis and then...
That's pretty cool, Gary. Innovative way to mount the dust shoe. However, I still think the router mount using worm gear clamps used on the...
I can send you the sketchup drawing and you can make it using your cnc mill... MG
