Separate names with a comma.
Some features disabled for guests. Register Today.
I was forgetting about the tool change! So helpful. I had trouble with the OpenBuilds post processor (my fault) so I went back to as basic as I...
Keith you are doing something wrong in the way you are setting up the machine. 'dragging the bit' means you have not set the machine coordinate...
Hey Stan. I watched the video and ran through the code(was at work earlier) and I'm in agreement that it's software related. The problem you're...
Technically, CONTROL is just a Host, you may be referring to OpenBuilds CAM :) CAM has limited Gerber support (Tested against Eagle) so can't say...
So you changed it in the gcode file at the start (line 22) but not in fusion360 post options, so the ending G53 G0 Z-0.3937 is what dragged...
Workflow above looks good (though you can eliminate the first step too, you can draw the 2D lines in the Sketch mode of Fusion360 directly -...
I believe the right thing to do is to teach users as early as possible that turning on with Z high is the right thing to do, always. This makes a...
The problem is in your Machine Coordinate System (also known as home) and your G28 settings. The controller uses several offset coordinate systems...
Hello Dennis, Electronics and software are usually the confusing part. Electronics can vary a little depending on the control software, but it's...
Alright folks, I did a whole lot of testing the past two days. I will upload some pictures of the results when I get back home. But based from...
To run the router you use an Arduino+GRBLsoftware+a driver board (or a TinyG or other controller) If you use a dedicated controller like the above...
indeed, you cannot have cutter comp in GRBL, it might come to grblHAL in the future, it has been discussed but I cannot find anything that says it...
The only thing I've defined is the interest in building a small format Ox for the purpose of personal use. I've made no statements of a required...
Congratulations on your decision. The :)beam is a great machine. From a software standpoint it sounds like you're on the right path. You're...
