Separate names with a comma.
Some features disabled for guests. Register Today.
Using angle finder is not the best way to make sure your sled cuts true. The best way is to use the 5 cuts system to calibrate your sled. The sled...
You could start by buying a 3d printer on Aliexpress for way less than $200 shipped. Something like this for example. The electronics and many...
Read this. It will help you with your task.
gibson, did you look under the 'Files and Drawings' tab at the top of the page?
And bloody expensive! I think it was something like US$100 or $150 to get in to the site! :eek:
Of course it is possible, John! It's called a Rhombus. To have is all square you the angle between any two of your green lines has to be 90°....
I'm not familiar with Estlcam but mostly the limit switches, when triggered, short circuits to the ground which tells the program that a limit...
Limit switches are comprised of two parts. The switch itself and an actuator. Install the limit switches on the alu plate and the actuator/lever...
That link gave me a 'Search Error'.
How come there is no spacer with the hing? Wouldn't it squish when the screw is tightened?
Scotty, is that a cream-cheese/sour-cream tub that is encasing your diode?
The hollow shaft is a great idea. You could make the lead screw almost any length and have no whip.
Maybe everything is squared except for the stepper motor? Maybe it doesn't sit 100% flash in it's location?
Put the VFD as far away as possible from the electronics and/or put the VFD in a metal housing that is grounded. Also, as beazlybub has writtne "...
I think that before you start pulling it apart try screwing the frame to the table and installing some plates on the corners. You'll need about 20...
I would get the mushroom type Emergency Stop switches. I got two of them on my machine. One on each end. I can hit them faster than searching for...
That picture is wrong. It would have been correct if the arrows where on the left side. Just to make it clear. It's YOUR machine. YOU determine...
:ROFL::ROFL::ROFL::ROFL::ROFL::ROFL:
There is not much you can do about the buckling of the thin material. Only three things come to mind. A vacuum table or screwing the part down in...
the stl export option exports only 'grouped' parts. If you have all the pars selected it will export them all in one file. If you click on each...
