Separate names with a comma.
Some features disabled for guests. Register Today.
Correct, they are not seperate anyway Most likely if its running, the spindle is still on, so run the light off the Spindle relay (SSR) PS:...
Yes, as used on the LEAD machines for example: [ATTACH]
OK so yes, NO/NC relay has since been fixed . But these are older than the change. What's your use case for the relay, perhaps we can make...
Disconnect CONTROL from the device 1) Download the attached file and extract it 2) Download xloader...
BlackBox 4X or BlackBox X32? The tools for the older one is no longer available, you would have to flash manually
How to calculate V-Slot® deflection Might be a bit much - its M5 fasteners and 20x60/40x40 extrusions
CONTROL > Grbl Settings tab > Select machine from the list and Save and Reset. Our profiles sets default pin configs too Custom firmware can be...
Maybe did you set Laser Mode to Enabled in Grbl Settings by mistake?
And
What version are you on? Haven't had jog bugs in a while OpenBuilds-CONTROL/CHANGELOG.txt at master · OpenBuilds/OpenBuilds-CONTROL but always best
Software up to date? (CONTROL v1.0.376?) Using Continuous mode (make sure you aren't in incremental)
Or other way round. Just match up $5 Invert settings. Without filters Normally Closed might be a little better
1) Read the rest of the Grbl Wiki (: its really in there 2) apply your new knowledge on Max Rates
You only want it to show triggered when the bit touches the plate. Any other triggers are a short circuit somewhere (from your symptoms possible...
Recalibrate your steps per mm (about 25% of current values, 20/80=1/4=0.25x) : Grbl v1.1 Configuration
Further proof of Proceed to look for a GND to EARTH short somewhere in the system. Might even be inside the troublesome laptop's power supply,...
Says probe is already triggered (short or GND fault?). Check Troubleshooting tab. Does it go triggered soon as you touch the magnet to the spindle?
Might be a bit fast for drilling. Why not just machine with a center cut endmill? Or V-bit to mark center and then take it over to the drill press?
Thats the intention of a analog 0-10v output, as described above Unsure, 3rd party VFD. Manual, VFD supplier or trust the community writeup?...
What material? What spindle? What machine? (:
