Separate names with a comma.
Some features disabled for guests. Register Today.
also check Fusions heights tab for that operation.
those LED lights can also be noisy. my LED kitchen lights interfere with my TV in the next room, have to adjust the bunny ears for best picture...
that is EMI and just adding ferrites is not enough. you also need - star grounding - space between power cables and signal cables. You cannot...
check your Z axis, if it is moving a bit sideways you will see it on the X if the X skipped steps then it would not return to the correct path,...
Grew up and live in Grahamstown. Lived in PE for a few years though.
for 1. I'd say there is something stuck in one of the wheels that it is jumping over. does changing the job speed make any difference? does...
The problem is in CAMOTICS as it does not correctly interpret nor display G53 moves. I maintain and USE the OB fusion post, and I would have...
no, not at all.
does the same job run slow everytime? if so, you should turn on smoothing in fusion so it generates fewer lines of Gcode [MEDIA]
Yes of course, read about it in the manual or big blue question mark in the toolbar if you have no internet (-:
had that since day 3 after the big Fusion change. (-: it uses a state change loop to detect MMMM and then MMMM with the MMMMM until MMMMMM....
Use the OB post for GRBL. MAch3 should be happy with it, and it reinstates most of the rapids...
Rather use the correct post processor so it is always correct and you don't have to remember to fix it for every project
This Gcode cuts 6mm deep around the outside of the sign, you can see a Z-6 in the last block, so no problem there. This should help you...
I wish you had included the entire Gcode file as an attachment. I believe it will show that you selected the bottom of the part as origin in...
The G53 move is a safety move, an industry standard for preventing expensive crashes. Z home is the top of Z travel, so moving to Z-10 raises the...
1 - The rattling noise means that your GRBL calibration for 'max rate' is too fast, and possibly also the acceleration values. Set them much lower...
yes, you must select a laser tool for laser output
After you have probed the front left corner of the material, do the numbers on the display show 0's for all axes with the tool at 0,0,0 correctly?...
make sure you always turn on with the Z as high as it will go. and read this for full details on why and how
