Separate names with a comma.
Some features disabled for guests. Register Today.
read docs.openbuilds.com 'GRBL Settings' tab in OpenbuildsSCONTROL has all the GRBL settings visually represented for you.
My guess is that the documentation for the drivers will tell you how to set the DIP switches for microstepping. without the actual drive (google...
which drive, on what machine, belt or screw, what controller and what drivers?
Hmmm, never mind, for now.... Fusion does not have a pierce height entry field. We would have to have that in the post options which then has to...
Is this a wireless mouse? I have had weird button sticking problems with 2 different wireless mice, a Microsoft and a Genius, absolutely no...
look for the Z depth you were cutting at and restart there so your are cutting 5 passes, lets say 2mm deep per pass, for a final depth of 10mm...
please read my question again, I asked what you are actually selecting, so a screen shot of your selections would be fine, plus a screen shot of...
'same amount everytime' is probably backlash, check that the grub screw in the pulley is firmly on the flat of the motor shaft. did you pull the...
When power is on do the motors lock up so you cannot turn them by hand?
The X axis lost steps. Belts tight? (use a fishing scale to pull to 12kg of tension) Pulleys properly fastened with the grub screws, one screw on...
This tells me that the LEad1515 settings are too fast for your mechanicals, which means that the Y side that lags behind is too tight. disconnect...
In the Serial Console you see all GRBL settings in a 'raw' form [ATTACH] In the GRBL Settings tab you see the human friendly display of the same...
if you tell me what options you are selecting in OBcam for your plasma cuts I can make the Fusion post do the same Gcode output, this will benefit...
You do know that this OpenBuilds/OpenBuilds-Fusion360-Postprocessor post processor for Fusion360 does support plasma cutting, right?
Well, it sort of does support it, MacroB is one specification, and LinuxCNC has elements of it for implementing loops and subroutines. I don't...
I think it is the X axis acceleration (-:
sounds like a wiring issue. during use, the motors vibrate, and so does the router, so grub screws, motor mount screws etc can easily come...
or if you had a breakout board (BOB) with open collector outputs, they can only pull down so you get an 'active off' signal.
ok, I have got it.... I think drivers need a small delay between the change in the direction pin and the next step pulse. I believe Mach3 has a...
cannot be that, the enable lines are not wired in at all. please confirm that the motors lock up when power is on. if they dont you have a power...
