Separate names with a comma.
Some features disabled for guests. Register Today.
Those are not suitable for home/limit switches. What are you going do with the switches?
Last week I was doing about 70 inch a minute on my belt drive OX, 2mm 1flute bit at 18000 rpm in MDF. 100"/min is not impossible, I do that when...
Thankyou, I meant the source for OpenBuildSCONTROL. GRBL (in the BlackBox) knows very well about the WCS. But OpenbuildsCONTROL does not, and that...
You can type G54 , G55 etc in the Serial command box (and of course have matching settings in your Gcode but, you cannot at this time use the...
If it is not software then it is hardware.... changing acceleration and maxspeed down will increase power, but you say that did not help, so there...
This will work assuming you are ALWAYS 'faking the home' or have home switches in use, in other words, GRBL is always reset with Z up high as it...
hmmm, maybe. I would like to see your original drawing and an explanation of exactly what you were trying to do, I cannot quite picture it....
if Vectric can do an http request with multipart form data from a plugin (could be the post) then this would be possible. I have added a button to...
strange, I have never had any such problem with mine, I wonder what I did right? (-:
maybe a high contrast 'black and white' mode for laser users?
on the topic of 'accuracy' we need to carefully separate 'precision' and 'repeatability'. Precision is where instructing a 100mm move results in...
good! That is exactly what is happening. without feedback it is called an 'open loop' system. GRBL (the firmware in the BlackBox, read all...
now watch the attached video note: If you want to cut inside the 3mm wide rectangle your bit has to be smaller than 3mm if you want the slot...
Yes but You will need to figure out the difference in height between the sensor and the table and use that in the probing macro. Your Gcode must...
You can do the drawing AND the Gcode in Sketchup draw the flat rectangle of the size you want set the cut parameters for SketchUcam add the...
Use the wizard? [ATTACH]
No I don't think so. Sitting on the flat table is part of what keeps the LEAD frame aligned (no machine tool is independant of the mounting...
No, the GRBL firmware is now using up all the spac in the microcontroller, there is just not any space to store tool offsets in the controller....
do a tool change with Z all the way up. go to probe position, Z all the way up. probe from tool0 Z, long way down, takes time. if we can rapid to...
yes and no. yes in that it will work (except for limit crashes), no in that you now have the maximum travel to probe for every tool, every time....
