Separate names with a comma.
Some features disabled for guests. Register Today.
Check with Fuzztech. They are showing 50 in stock.
Actually, 4.2mm is for cut threads. For formed threads 4.6mm is recommended. And if I had one, I'd give it a try but as these screws don't have...
@Donald D. Parker, have you tried Autodesk Trueview? It will allow you to print to scale and will work with the dxf files provided in the OX build.
Gray, it all depends on the forces and how they are applied. You would never use the inner wheel mounting the Z-axis carriage to the X-axis as...
Darrell, it all depends on the nature of the system and the forces applied. It might even work with just 4 of the small wheels. I did a mock-up...
Those are no different than the 1000mm C-beam kits where you won't see a support either. The discussion here is in regards to much longer...
Darrell, I understand your confusion with the SKU 900 Extreme V Wheels. Most of the pictures shown on that page are of the Solid V Wheel. This...
Yes, just a smooth hole in a guide block. That is all that's required to provide support. If you tap them, they move with screw movement and the...
You'll actually want the supports to slide freely along the screw rather than be tapped and move with it. Here are a couple suggestions: Connect...
Bill, the useful length of screws maxes out around 4 feet unless you get them in a rather substantial diameter. Igus can supply the length you...
Arctic Silver Adhesive.
Suggestions for integration of the C-Beam Linear Actuators into the OX system. (file attached) Just a few quick ideas. Moving the lower gantry...
Two 1500mm lengths bonded back to back would make one heck of a nice bridge beam for a wide format router table. :)
Where did you find the 1/4-20 nuts that fit the track?
Drawings are on the files tab. Spacing is section depth + 19.8.
A note to the followers of this thread, the OX plates have been revised to version 8.1 to resolve tightness of the Z plates on the X axis.
This issue was noted a few weeks ago in the OX thread. The problem is due to tolerances in the extrusion that have changed with the latest...
Yesterday I was doing a bit of testing regarding threaded holes for 5mm screws in Delrin (aka POM, acetal) and found that a 3/16" drill bit...
If the pre-made units are too big, make your own. It is really not that difficult. Ref:...
As the same machine can be built in either a 2x4 configuration or a 4x2 configuration merely by adjusting the length of the rails, it become...
