Separate names with a comma.
Some features disabled for guests. Register Today.
For belt drives it is best to use a dual belt or servobelt system to reduce the amount of stretch. The best explanation comes from a video...
Sorry Gray but I haven't had a chance to take this any farther. I'm still putting together the OX to attach it to. And between work and cold...
Try Autodesk Trueview. They open fine in Trueview 2014.
Belts are not joined as such. They start with a continuous length and then are either clamped off at the plates or at the end of the rail....
The only reason I know is because the issue has been discussed previously on the forum. I have no connection with the shop (and I'm only a...
This is one of those unforeseen issues that came from the shop upgrading to the 10mm eccentrics. While the 10mm eccentrics greatly benefit the...
Possible, yes. Whether it will be well suited to your needs is another issue. Belts stretch and this may have an impact on usability.
The configuration (hole layout) is not appropriate for the OX machine. That plate is also a bit thin. If you are wanting to build a router...
The original OX was built with this combination: https://synthetos.myshopify.com/products/gshield-v4-shapeoko-bundle. If you already have the...
Invest in a UPS/battery backup system, you'll be glad you did. Even the little one I have gives me 5 minutes to shut down and controls any...
Nope, it's correct. The screw has to pass through a 3mm plate first. With the 1.5 inch spacer this leaves 3.9mm of thread to connect into the...
The gantry is the X-axis. Long side rails are the Y.
For a production shop, it might be good to just have another 611 motor unit on hand so you can swap out and keep the project moving along.
You'll find that while GT3 doesn't mesh perfectly, it meshes more than adequately when trapped beneath wheels in the trough of V-slot.
Through the model info dialogue box, you can set Sketchup to 1/64" if you wish to work in inches and up to 6 decimal places if you work in...
Top line http://www.cncrouterparts.com/cnc-motor-cable-p-45.html
You might contact them about this as it may be a software glitch they are unaware of. I've seen it before with other new sites and when contacted...
Outside slots are 3mm so moving the wheels out is not really an option and shifting the plate down is not an option because the shaft hits the...
Best suggestion for now would be to check with one of the other distributors like http://www.opensourceluthiersupply.com/ and...
Actually there shouldn't be any axial forces on the drive axle. All the force should be either radial or lateral. As far as shimming, I had just...
