Separate names with a comma.
Some features disabled for guests. Register Today.
Try Interpolate circle with polyline - QCAD.org Forum - didn't test myself, just first result on google
Its a lot of work to pop out the bearings, plus if the wheels are worn, bearings are far along too. Hard to dislodge the first bearing, by prying...
They don't have a decent datasheet? But I am going to guess that its not going to be a great match: BlackBox likes motors with 3v coils, 1-2mH...
Then it is dead. You can contact the store via Support > New ticket - but again, do keep the note in mind, if what damaged this one happens again,...
What's the machine itself? What kind of drive system? More info you give the better the guesses we can try (;
Any chance the compressor tank had trained during the nicer bit, then kicked in the compressor to run - while it was making the choppier bit?...
CONTROL > Grbl Settings tab > Scroll down to $111 Max Rate for the Y axis. Change value. Save and Reset when prompted Grbl v1.1 Configuration
Our Acros runs around that low too (high speed belt drives) OpenBuilds-CONTROL/app/js/grbl-settings-defaults.js at...
Great then finally the drivers are fine. If it can read the ID then finally the drivers are no longer the issue. Back at Blackbox X32 - Driver...
What are you changing? Ps, for steps per mm, forget decimals. Its Steps per mm. Step being the lowest physical increment the machine can move....
Does it show as NodeMCU in CONTROL yet? Latest Device Manager screenshots shows the right device name at least PS: With all these things ONCE is...
Feedrate = speed of the move = set in CAM It should pierce on the entry of an entity only. But now that you mention it - are you sure you have...
Could also be feedrate (moving too slow - blows away too much material below nozzle) or air pressure related cnc plasma arc extinguishing - Google...
So our typical recommendation is to use a floating head with draggable consumables. Wrong consumables can "blow out" the arc if dragged on the...
(; Seem to "work around" more like it. The short is still present and someday could cause mains leaking into the DC domain damaging controllers,...
It doesn't stall in this video But the leadscrew sounds dry - spray some Dry/PTFE lubricant (Don't use oil it will degrade the Delrin nutblock)...
What kind of Inverter, and what kind of Nozzles do you use? (Blowback with Draggable tips?)
:) something with an FTDI would have been a better test (;
I think we asked before, but just double checking. These are genuine Arduino's (TM) - not ebay specials (might not have standard firmware on the...
