Separate names with a comma.
Some features disabled for guests. Register Today.
Ran it through a BlackBox with Check mode Grbl v1.1 Commands enabled no issues (Also not near machine) [ATTACH]
Yes but which USB chip. FTDI, Silabs, CH340 or ATMEGA8U2 Or closeup pictures of the board / USB device info from OS
Something else I am thinking of, what USB chip is your controllers using? (If its not a BlackBox)
That's March 4th, and was already analysed: Thus, post the new stuff too...
Post your files too - greatly cuts down on "lets see your latest files" question having to be bounced back - the more you include (logs, fusion...
Yes, overheating is covered in docs:blackbox-x32:currentadjustment [OpenBuilds Documentation] Fan must spin or it will overheat again. Try...
At first yes, the additional uncalled for INF steps - not sure If correctly installed you should see it in Device Manager under Ports [ATTACH]...
In your video (....1111425.mp4) you move one Entity, not the entire document. Select everything to move first (ctrl+a, or use the Selection tool...
INF? Per docs:blackbox-x32:install-drivers [OpenBuilds Documentation] we link you to the nice Installer version (EXE) Perhaps you do have the...
Stock is on the conservative end (can usually tune upward) unless there are any 3rd party parts involved (different steppers, different PSU,...
It shouldn't so how are you doing it? Using the Move tool or the Transform (type values into boxes to move stuff) tool? Are you paying attention...
It could be that the strategy is a bit aggresive, but the repeatable offset "feels" more mechanical - if the cut recipe was off I'd expect it to...
Sure its a 1/4" shank? 6mm shank bits installed in a 1/4" collet feels like they fit, but pushes the endmill deeper during plunge cuts (not...
Plasma On/Off is in the CAM setup - totally different application Check the dates of the video, BlackBox X32 is newer and V1.3 upwards uses the...
Also, don't use 100mm, use as far as you can move per axis
Settings can't affect connection, so do go over that wiring, before its too late (: Still either stalling (Acceleration/Max Rate set too high)...
Before or after? What's differences between the two jobs? Down to "i did perform a toolchange" or any other cluea to go by?
You already have a store ticket, will check in and have them swop it out for you for the USB issue. (; sounds familiar - see Page 1 of this...
You only need to install drivers once. Does it connect now? If so. Drivers: DONE Fan and Motors needs POWER. If neither works, you don't have 24v...
Shorts in cabling somewhere? Could kill the BlackBox. See section 6.3.1 of the FAQ page the onscreen error in CONTROL was pointing you to:...
