Separate names with a comma.
Some features disabled for guests. Register Today.
@Lewis Trafford would you please contact the Store via Submit a ticket - we'd love to swop out that BlackBox for you - so we can investigate yours...
VFDs in general are somewhat generic, existing writeups read along with manuals should get you there. Just we can't officially say yay or nay as...
Your VFD vendor would be better able to answer the VFD specific questions. We provide the 0-10v signal, and most VFDs can be configured to ignore...
What control system / stepper drivers ? Whats the application for these two motors? Load / Torque Expectations? Sync'ed as in both perform the...
We have seen switches break - especially if rammed hard with the machine Motor weirdness? docs:blackbox-x32:faq-identify-motor-coils [OpenBuilds...
Will check into it! Good catch, thanks
The noise in the video sounds like the first section of Pay close attention to the fact that page covers both initial wiring, but also, more...
Theoretically. Though impractical in some use cases. Rather than this generic approach, how about you begin with what you actually want to do, so...
Up to 360w. For our motors, you are looking around 18w per motor
If the Blackbox regulator was damaged, you would have to replace the Blackbox. Do recheck all wiring - what killed that one could still kill a...
Fiberglass composite Yes as long as that controller accepts 24v
F7500 = 7500mm/min. 60 seconds in a min (not 100) 7500/60 = 125mm/sec
Yes! Check out Purchase Orders and Contact Us
Which relay module? Plenty of the cheapies only have Active Low inputs (replace with one that accepts Active High signals). Some of the slightly...
Same thought - though with that state partial teardown to do a good clean might be a good idea - relube leadscrew, clean nutblocks, the whole...
See docs:blackbox-4x:currentadjustment [OpenBuilds Documentation] - fault indicators are documented in the 2nd half of the page, though the first...
Show us what your macro looks like, serial logs etc. Pretty sure they wouldn't disable G4 THC is over complicated and mostly unnecessary on a...
Been about 14 months since the old one was in stock. Don't make them anymore
Remember to load machine profile after the clean flash. But not your old backup - as it might have some incorrect settings.
Well, there was some attempt at a custom build. Rather than worry about what might have happened there, lets get back to stock and test. If...
