Separate names with a comma.
Some features disabled for guests. Register Today.
If the firmware specifically requests a Reset, you need to reset, not unlock.
The link would have advised to check the Fault LED first, if that is what comes on, it should have been turned down. Just something to keep in...
Our post does add it: docs:software:vectric [OpenBuilds Documentation]
Checkout their documentation, found this for you Flashing Smoothie Firmware - Smoothie Project
2000 seconds is a bit long No parameter would error yes
What do you send? G4 P2 = dwell in place for 2 seconds
Would raise an alarm onscreen. Was there a popup error? If its always the X motor, see docs:blackbox-x32:faq-identify-motor-coils [OpenBuilds...
OpenBuilds-CONTROL/index.js at master ยท OpenBuilds/OpenBuilds-CONTROL
X32 does not need 2 axes firmware. Homing sequences can be set in Grbl Settings now ($44,45 etc) as masks edit: assume you mean 'does not need' (-:
So you say the motor spins. Does the leadscrew spin? Is the leadscrew in the nutblock? Is the nutblock attached to the plate? If the motor is...
See Grbl v1.1 Interface and Grbl v1.1 Commands Apart the command, do you have the queue management, newlines after commands ("$X\n" for example)...
Forgot to tighten setscrews on the shaft coupler?
That sounds correct. Current set a bit high
Checkout the documentation docs:blackbox-x32:currentadjustment [OpenBuilds Documentation]
Check your Grbl Settings : $44=4, $45=3 should do. If not post a Grbl Settings backup for review
Correct Fix in $5 Limits Invert ($5=0 or $5=7 - opposite of what you have now) Did you remember to enable Hard Limits in Grbl Settings NO!...
Review the complete thread, there are in depth discussions on Vectric workflow, Post, Calibration etc. Its already in this thread, just start at...
CONTROL does not support host-pause commands at this time. Some other hosts might.
If you keep it as a Y you can just use the standard Wrapping function in Vectric. Check out LEAD Lathe
Maybe you set your browser to show Desktop site? Haven't been any changes to OB in a long time. [ATTACH]
