Separate names with a comma.
Some features disabled for guests. Register Today.
If you want to confirm if a store is a legit reseller you will have to check in with the OpenBuildsPartstore - they will be able to advise if its...
They have higher inductance than ours, so dial down Acceleration and Max rate to at least half, or even 25% of the current values CONTROL > Grbl...
As per your other support email, we do note you lost 2x controllers before - so do make sure to replace the PSU and any other suspect components...
Yeah, that's why I am kinda pushing for it - if you do go for a Weho or something else, its again not the one we design and mass test against, so...
The PowerCase does not add any filtering. We trust the Meanwells enough not to need to. That might be a Weho, not a meanwell though, so do check...
If its an official OpenBuilds Reseller they will have an approved PSU available. Meanwells are sold on Amazon too (just watch out for clones with...
Voltage 3-6v? Current 1.7-3.0A? Inductance in the 1-2mH range?
Yeah I am definitely going to recommend you grab a 24V Meanwell Power Supply Bundle We see that often enough - budget cuts leads to them removing...
What power supply do you run the BlackBox off?
Interface is DC powered. Mounting to an AC earthed panel, might cause issues (or not, depends if the earth has leakage currents or other bad stuff...
For 3rd party machines we can't offer much in terms of guidance as we don't know the machines as well as ours. Does it have a VFD? Mixing AC...
Not our motors then? Are you sure their electrical specs are suitable?
Make sure to set Homing Cycle to something other than 0 If its just troubleshooting tab, check your report mask. Otherwise, check that Hard...
If its similar to our type of machines, you should be able to. Work your way through http://docs.openbuilds.com/blackbox-x32 to see what it needs....
The "login" at support is for agents. You just make use of the New Ticket form. Yours is in queue, just hang tight for a reply via email. They'll...
They should be fine with our default profiles. You are using ours? The rattling noise is very much a symptom of wiring though, so work through the...
Having a couple cheapies to learn with is a good idea (they dull in no time, but is less of a loss when you crash them while learning cutting...
Have a read through the Grbl Wiki, might be Max Rate see Grbl v1.1 Configuration
Yes, that entitles the person to tech support, and it would just work. It contributes to CONTROLs development. Etc
Load a machine profile from Grbl Settings tab > Select machine from the list > Save and reset when prompted
