Separate names with a comma.
Some features disabled for guests. Register Today.
USB is NOT mentioned anywhere in that link. Pointless guessing wastes everyone time, but mostly your own Fault Indicator is ONLY (as per the...
That's all fine. With miniature tooling the secret is in the CAM setup. Spend a couple pre-bedtime hours on the University of YouTube to learn...
See docs:blackbox-x32:connect-nema17 [OpenBuilds Documentation] Also see docs:blackbox-x32:faq-identify-motor-coils [OpenBuilds Documentation] to...
Click the link. Read it. Stepper drivers doesnt have firmware.. X32 and 4X has no difference in that section (neither in documentation nor in...
As it had faults in your post yesterday : [ATTACH] I wouldn't say its surprising
I see two Fault LEDs in your pic So as above, then same advise applies
Likely MCU damage caused at the same time the laser damaged the PWM Pin. Consider replacing it, as unfortunately it looks like a V2.7 making it...
Motors Enabled should be lit too. Post your Grbl Settings backup (CONTROL > GRBL SETTINGS TAB > BACKUP SETTINGS BUTTON) V2.10 perhaps? (two...
No need to (as you'll see if you work through our docs and videos, its not mentioned anywhere, because its not needed and doesn't matter) but if...
Have you checked for the indicator yet?
Wouldn't result in Stalling would make the tell tale whining sound. Bad motor wiring would make the tell tale rattling sounds. Half of technical...
Described in section 4 of docs:blackbox-x32:faq-identify-motor-coils [OpenBuilds Documentation] But probably more likely related to...
Y Axis Fault Indicator lit up? (red exclamation mark icon on the front?)
Check out our version of that: https://docs.openbuilds.com/interface
Wire the 2nd Z motor in parallel, just like we do for our MultiZ machines: Multi Z LEAD Machine Addon
Thats where that came in. Its a suggestion but please Tune it. If it overheats turn it down! See the DOCS it describes the Fault LED too lower...
About halfway up, as a start, but see the docs
All the way down docs:blackbox-x32:currentadjustment [OpenBuilds Documentation] for our NEMA17s. Voltage is automatic, but you have to set the...
Lovely feature well done
Sweeet. Each file has headers etc? So can power off and come back next day, home and run?
