Separate names with a comma.
Some features disabled for guests. Register Today.
Unfortunately we can't provide a definite report for you, as there are a lot of variables at play, also cannot rule out user error. As for the...
Absolutely, bad quality chinese module by any chance? Accidentally incorrectly wired? Well, unless you have Laser Mode enabled? Surely to test...
That should run fine :thumbsup:
Then its stalling or similar, so If in doubt set existing values for acceleration and max rate to half. Do mechanical inspection (forgot to...
The 0-10v output should scale +-0 to +-10v yes. See docs:blackbox-x32:connect-vfd [OpenBuilds Documentation] Well yes, if something killed the...
Not familiar with it, but do check its motors electrical specs (voltage, inductance, resistance)
Similar to how we did the Fasterproms Table? [MEDIA]
Still very much unstable FluidNC support · Issue #283 · OpenBuilds/OpenBuilds-CONTROL with tonne of todo work. We'd love to work on it but this...
You really have to go read the Grbl Wiki. MCS is explained in the FAQ page That alarm is explained in the Max Travel section of the Config page....
Does the Z work correctly. Can only calibrate (dial out manufacturing tolerance) on an axis otherwise already perfect. Wiring, mechanical,...
Nothing special here. Just Min Freq not set correctly. See it often... Spindle max 24000rpm = 10v Spindle recommended min = 7200 rpm 7200 / 24000...
$5=7 (all switches normally open) or $5=0 (all switches NC). Any other values 1-6 inplies some mix of NC and NO mixed (unlikely)
Please contact the Partstore via Support > New Ticket for assistance
Yes, because You have not set up Min Freq on the VFD properly. Pwm is Never 0v thats why every VFD has that setting
You forgot to set VFDs min freq parameters. Should fire up under 100hz for water cooled or 120hz for air cooled. See VFD manual
It should work, screen recording as above You can check it its in the Documentation: docs:blackbox-4x:jumper-autoreset [OpenBuilds Documentation]
Borrow a friends, take it to work. Ask the neighbour.
Works just fine in testing... As it should and always has [ATTACH] The Servo firmware is still 1.1f, so you haven't flashed it (correctly) yet....
Not ANY, Z up as high as it goes, XY at axis maxima would be good too
Check the provided link on this page Interface Mounting Kit Anything will do, we like the size and shape of that one for sticking onto V-Slot
