Separate names with a comma.
Some features disabled for guests. Register Today.
Lots of SPI based TFTs you can wire up. Google is your friend when learning a new (warning very addictive) hobby. Even get ESP32s with onboard...
Check out OpenBuilds Modular Enclosure System Any spindles own noise is well drowned out by the actual cutting - endmill flutes hitting material...
Laser heads have adjustable focus built in. A Z axis is hard to do with Flying Optics. If you do decide on some sort of Z a bed that can raise and...
The Blackbox X32 uses the simpler 0-10v control system (instead of modbus/rs485) which is usually a lot easier to configure. See...
If you skip Grbl and use AccelStepper you could fit LCD libraries too, or skip the Arduino, get up to date and use an ESP32 - no more worries...
Sounds like an Earth (spindle body) to DC GND (supposed to be seperate) short circuit somewhere. See XYZ Probe Plus with VFDs and other...
No its not, not an intended use case sorry
Should not be needed and would likely make it even harder to tighten | Make sure the opposite fixed side wheels are correctly installed - pushed...
Restore your last good backup. If you did not take a backup (CONTROL > Grbl Settings tab > Backup Settings button) you'll have to reconfigure by...
Yeah CONTROL has not been built for android, you can run CONTROL on a PC and access its web interface from any device, but to run it you need...
OpenBuildsCONTROL has a nice Saw stop macro: See Getting started with Javascript Macros in CONTROL / Library of Macros created by the community...
It's not as much an issue as a workflow - after an alarm/error you should clear it: Alternatively use Compatibility mode: But that disables...
a 5kg load will easily backspin an 8mm pitch leadscrew The weight = massive loads at the speeds you expect, it is quite complicated in terms of...
Yes:
How I Made a 4th Axis Harmonic Drive - BrainRight Should be worth a read/watch
Work through the provided link please it goes in depth on what to look out for, and to diagnose.
Then its likely been damaged, recheck the page, paying particular attention to section 6.3.1 - you'll want to find what killed it before replacing it
Check out docs:blackbox:faq-usb-connection-failed [OpenBuilds Documentation]
If they've worn down too short dewalt 611 brush replacement - Google Search
I meant in terms of tooling diameter - running some 1 inch router bits with a 6.35mm shank? Or running standard endmills. Speed - router always...
