Separate names with a comma.
Some features disabled for guests. Register Today.
Our official number is 199.1 - its a rolled screw, precisely 200 is theoretical, but unlikely to be correct. Was there a change in error rate...
swop pins 1 and 2 of one motor only
Off in both direction by the exact same error? X and Y? if so, do post the gcode please
PS: The whole Grbl Wiki is good bed time reading. Understanding the firmware's expectations, configs, ins and outs is a great ease to the learning...
Rapids (G0) is set as a Firmware config (Max Rate): See Grbl v1.1 Configuration Last sentence of the section: "NOTE: This max rate setting also...
As its a custom machine, as you sure you have it started off with our CUSTOM profile on the Grbl Settings? Check that you have $10=511 and $4=0...
Just install CONTROL, plug it in, and connect. Don't load profile or anything like that (will overwrite current settings). Just use it as normal...
Saved on the BlackBox. But do remember to take a backup from CONTROL > Grbl Settings tab > Backup Settings button sometime to avoid future worry.
Also make sure you have the actual FTDI driver, some included CDC drivers in Mac can be flaky too docs:blackbox-x32:install-drivers [OpenBuilds...
It is, but harder to wire, so I avoid the suggestion as long as possible. Read docs:blackbox-x32:faq-identify-motor-coils [OpenBuilds...
Sounds like EMI, checkout docs:blackbox-x32:faq-emi [OpenBuilds Documentation] - any 3rd party components like a VFD spindle in use? Dust extraction?
Is that ballscrews?
Lightburn is a CAM. Lots of CAM applications. A CAM converts a CAD file to GCODE
No i dont mean time. I mean 1) using docs:blackbox-x32:currentadjustment [OpenBuilds Documentation] to add a little (very little at a time)...
Ok, when adding the 2nd motor, did you add a little (just a little at a time, to avoid overheating) current to Y1 to compensate for the extra...
Your job is where it is. You can tell the machine where your Job origin (0,0,0 point) is by jogging to it, and setting zero Where the job is, is...
So if you do Y's seperate on BBX32, does that improve. It should be the same or better as 4X when correctly set up per...
Are you using our PSU? I am trying to see what might be different in your setup. We run BlackBox with our motors as dual Ys all the time. Up to 3...
It shouldn't be huge. But some difference is expected. The other issues of Fault Indicators etc indicates something is wrong first that when fixed...
Doubles will be a bit slower, but we run 3x motors on these kits Multi Z LEAD Machine Addon on a single axis.
